Search results

  1. nola mike

    Outdrive Popping

    I can see maybe getting the engine out... But how could you get it back in? Guide the input shaft in as you lowered and moved the engine aft?
  2. nola mike

    Converting 260MIE RH to LH.

    So you just need a standard LH SBC starter, right? Are those hard to find used there (and rebuild) or am I missing something? Only because you can't get RH stroker parts, right?
  3. nola mike

    Mercruiser 5.7 won’t make power

    Which is certainly possible if you have a problem with the ignition sensor.
  4. nola mike

    Mercruiser 5.7 won’t make power

    The 2 wire version is. Newer ones are 3 wires.
  5. nola mike

    Mercruiser 5.7 won’t make power

    Sounds like it isn't in base timing mode
  6. nola mike

    Mercruiser 5.7 won’t make power

    Misfire... What wire? Why not? Use an advance light, rev to 2k and see where you're at No
  7. nola mike

    Mercruiser 5.7 won’t make power

    The electronics under the cap is the ignition sensor. Did you ever verify that your timing is advancing?
  8. nola mike

    Mercruiser 5.7 won’t make power

    His wot on the 3l was 23mph. He didn't mention rpms; your slip numbers aren't accurate
  9. nola mike

    MerCruiser 5.7L Low-ish Compression

    As good as what? The ones that he has with bad valves?
  10. nola mike

    Dies when throttling up from idle after warm up/ 89 merc 3.7 2bbl

    Not sure why you're quoting my post when none of my questions were answered or suggestions followed, but get an ir gun and check your temperatures
  11. nola mike

    MerCruiser 5.7L Low-ish Compression

    You buy one that matches your other head. Or you splurge for a pair.
  12. nola mike

    MerCruiser 5.7L Low-ish Compression

    1. Go to wrecker yard 2. Find one of the zillions of 5.7l engine there. 3. Grab a head for $20 4. Get a new head gasket for $50 Spend ½ day swapping. Go boating.
  13. nola mike

    Help and clarification

    The 470's first year was '76. So who knows what you have in there. Post some pics Edit: rereading... Do you have a 4 or 6 cyl? Don't think there was a 3.7l 6.
  14. nola mike

    Frost Plugs

    You can get a rubber plug for testing purposes
  15. nola mike

    87 Mercruiser 205 V6 losing power past half throttle

    Yeah, pour the contents into a clear container to see what you get. All of those stores rent tools, some you wouldn't think of. I've rented flaring tools, bearing drivers, balance installers, drum brake tools (!) etc. AutoZone and advance don't have a time limit on how long you can keep them.
  16. nola mike

    1995 7.4 Thunderbolt starting

    I've been thinking about installing a momentary switch at the helm to activate the FP relay. Obviously won't work with a mechanical pump...
  17. nola mike

    Outdrive Popping

    How/why did the engine get swapped without removing the drive? First thought is u joints. See if it makes noise on muffs, then pull the drive
  18. nola mike

    1999 Tige v21 inboard mercruiser engine (acts fueled starved under load)

    Why would any mechanic swap out the pump twice and the fuel gauge before draining the fuel, filters and going through the carb on a boat that sat 4 years?
  19. nola mike

    Engine no power under load

    Do we know what carb we're talking about? Is op talking about the secondaries?
  20. nola mike

    Swap a complete 1988 OMC 4.3 out and put a complete 5.7 Mercruiser I/0 complete with wiring harness in??

    V8 seems a bit of overkill in a toon, no?
Top