Search results

  1. Lou C

    Houston….. We’ve had a problem…..

    get a couple of pieces of 1/2" plywood about 4 ft long maybe a foot and a half wide, make a flat path, make your life easier. At my age there is no way on God's Green Earth that I'm wrestling with an outdrive. The jack makes it easy, with the Cobra I R&R it in neutral, and I use a thin long...
  2. Lou C

    Houston….. We’ve had a problem…..

    I use a drive jack to make that job easier. These cone clutch drives are very good the main issue is the cost of parts vs an Alpha is quite a bit more but strength wise these cone clutch drives are closer to a Bravo than an Alpha. In general I have found that the OMC transom mount was well...
  3. Lou C

    Houston….. We’ve had a problem…..

    My early driving days were in suburban/rural Westchester County NY. We discovered that with big & wide tires in the rear, old school VWs were nearly as good as Jeeps off road! Fire roads were our playground.
  4. Lou C

    Houston….. We’ve had a problem…..

    If you still had that KG & it wasn’t rusted good ones go for $35k. I had a ‘65 Beetle & a Fiberfab Dune Buggy built off a 56 Beetle pan. One engine between them! Put 2 scissors jacks on top of a reinforced creeper to swap engines after removing the fan housing etc. Would love to have a KG now!
  5. Lou C

    Houston….. We’ve had a problem…..

    Now this is vintage. I learned how to fix my air cooled VWs reading this book, I bought this copy in 1972 when I started driving and still have it, grease and all. Scott do you remember that yellow fibrous grease we used to have to use to repack wheel bearings? Nasty stuff! So learned points...
  6. Lou C

    1996 Four Winns Sundowner with 5.0 Cobra engine and drive

    Sounds good! Evinrude, Johnson & OMC Cobra were all part of the same parent company OMC later called BRP. OMC = Outboard Marine Corp BRP = Bombardier Recreational Products, they bought the assets of OMC after they went bankrupt in 2000.
  7. Lou C

    Houston….. We’ve had a problem…..

    who is old as the 265 cu in small block?
  8. Lou C

    Houston….. We’ve had a problem…..

    Not only that I think I might be even more vintage than you Scott!
  9. Lou C

    Houston….. We’ve had a problem…..

    And for those of us that are a certain age learning how to set up a points distributor & clean & tune a carb was like a rite of passage into adulthood if you were a Motör head.
  10. Lou C

    Houston….. We’ve had a problem…..

    I was lucky to have an un-molested marine QJet on my 4.3. Properly set up they start and run well and are quite economical.
  11. Lou C

    Best Battery for MerCruiser 888 (1976 Ford 302)

  12. Lou C

    Best Battery for MerCruiser 888 (1976 Ford 302)

    https://www.amazon.com/Atwood-9095-5-Heavy-Duty-Battery/dp/B00K8DBZ8U/ref=asc_df_B00K8DBZ8U&mcid=48d5c948b29639a28c03b86ce0571471?tag=bingshoppinga-20&linkCode=df0&hvadid=80333120120394&hvnetw=o&hvqmt=e&hvbmt=be&hvdev=c&hvlocint=&hvlocphy=&hvtargid=pla-4583932699527785&psc=1 this but be sure to...
  13. Lou C

    Houston….. We’ve had a problem…..

    However Q-Jet gaskets come right off, they don't get glued on like Holley gaskets do....there are so many variations on the Q-Jet because they were used on everything GM built from 1966-1986 or so, ranging from the OHC inline 6 Pontiac to the 454 Chevrolets and 455 Olds, Buicks and Pontiacs.
  14. Lou C

    Houston….. We’ve had a problem…..

    with these it isn't Rocket Science....pre Vortec = short plug, & Vortec = long plug!
  15. Lou C

    Houston….. We’ve had a problem…..

    Great glad to hear that the project it coming along well!
  16. Lou C

    Best Battery for MerCruiser 888 (1976 Ford 302)

    I used to use boxes but ditched them because: 1) the batteries never fit tight in them & move around 2) that strap always gets loose & the whole thing moves I have gone to battery hold downs & have the rubber insulators on the pos & neg clamps. Much better!
  17. Lou C

    Best Battery for MerCruiser 888 (1976 Ford 302)

    I have something similar (a pair of gp 27 Deka marine dual purpose batteries) & a 1,2,1+2 & off switch. This set up has worked well over the years for me…
  18. Lou C

    My 84 4winns horizon 195 project.

    Want a good laugh....from last years boat show..... this is an H-2, listed as a 22' boat but that includes the big swim platform, the interior is actually smaller than my old H-200 (20'9") and the price, is over $90,000. Frankly, if I'm spending that much on what's a 20 foot boat, it would be a...
  19. Lou C

    Leaf Spring Placement

    Looking at the pix again, it sort of looks like C hook springs are not the proper type of spring for those spring mounts because of how the fender mounts are bent (or appear to be) on both sides. Looks like when the spring fully compressed the C end bent that piece of steel which definitely...
  20. Lou C

    My 84 4winns horizon 195 project.

    Well I'd guess, $130-150K if they even made a similar model which I don't think they do. the boat I liked was a Steiger Craft 21 Miami, with a 200 hp outboard it was $115,000 but they really hold their value I would not buy another I/O sport boat for a number of reasons, one being poor engine...
Top