Search results

  1. alldodge

    2007 Hurricane GS194 Issues

    Depends on the pump and how you want to wire it This one also has high water alarm with additional float. So if not using high water just one single pole single throw (SPST) switch will turn pump on manually. To put on auto just turn switch off This one is a self contained where float and...
  2. alldodge

    1991 pcm nautique not able to crank after major flooding from carb

    Either brand new starter is bad, or something is rusted up. Start easy with pulling a valve cover, then the head based on what you find
  3. alldodge

    Starter won't turn over. New starter, new battery, fuel pump runs w/ key on 1999 Chaparral 2130 SS

    Unable to find a GL"5" but GL models usually have 2 relays next to each other Follow the Yel/Red wire coming from the starter solenoid to the relay
  4. alldodge

    Starter won't turn over. New starter, new battery, fuel pump runs w/ key on 1999 Chaparral 2130 SS

    The kill switch removes all power coming from the key If it was tripped then nothing at helm would work. The boat means nothing when trying to fix the motor. Which motor do you have?
  5. alldodge

    Mercruiser 3.0 140 dying out

    Sound like fuel system, running out of fuel. Remove fuel line and place into a container, then crank motor to see if you get a good stream of fuel pulsing Place container under fuel pump and remove filter. Is there anything but clean gas? What does filter look like?
  6. alldodge

    Starter won't turn over. New starter, new battery, fuel pump runs w/ key on 1999 Chaparral 2130 SS

    Welcome There are a couple things that will keep the motor from cranking. The neutral safety switch and the assist relay Turn key to start and hold, while in start move shifter forward and reverse slightly. Don't move it enough so it goes into gear, just trying to find out if its neutral safety...
  7. alldodge

    Stalling or Hesitating under load

    What voltages are you seeing, and is 5V exactly 5V ?
  8. alldodge

    Thunderbolt IV

    It's common issue with Tach and time. The Tach is shorting out and needs replaced. Reason it ran ruff is motor had excess gas that need to burn off from not starting
  9. alldodge

    Retiring

    Edited your message to stay within the rules Remember PM folks
  10. alldodge

    Need help with adoption issues re: deceased parent

    Sorry to hear, found this on SSA site. https://www.ssa.gov/pubs/EN-05-10085.pdf
  11. alldodge

    Engine will spin up in RPMs boat hardly moves

    Normally yes, the coupler is on the back of the motor. Without more info it's either the coupler or the prop hub.
  12. alldodge

    projects other than boats

    Might give a boat mechanic envy
  13. alldodge

    Engine will spin up in RPMs boat hardly moves

    Welcome Most likely its the engine coupler. Did you smell anything like burnt rubber?
  14. alldodge

    projects other than boats

    I like it
  15. alldodge

    Need Help with 8.2 Mercruiser

    What is one of the motors serial number? Don't see a warning sounding if motor has 2 bad cylinders, weak on power sure but warning, that's a hard one to understand. If power was weak on only one then you should be able to turn more RPM on the other Get the motor scanned for codes ECM may...
  16. alldodge

    Thunderbolt IV

    As @Bt Doctur mentioned, most likely your Blue/white wire is actually a Blue/Tan and goes to the oil pressure switch. The Blue goes to the oil gauge sensor The Blue/Tan goes to the oil switch. Edit: scratch the fuel pump comment, Tan/Blue sounds the alarm if oil pressure is lost Double edit...
  17. alldodge

    Water in Oil

    Power steering cooler has no connection to block. If PS cooler was leaking oil would come out the exhaust
  18. alldodge

    Water in Oil

    Not the drive, maybe on the exhaust but you said they are new. Pull plugs and see if any water is found on the plugs
  19. alldodge

    Water in Oil

    First suspect would be the intake gasket Next, was thread sealant used on head bolts?
  20. alldodge

    Volvo Penta OBD port

    RINDA Rinda makes the Techmate Pro and Diacom software, both need adapters to connect to motor. Each version of a motor may need a different adapter. Use their selection tool and it will show which ones will work
Top