Search results

  1. C

    2001 evinrude 4 stroke wont run over 2900 rpms

    suggestions only... up to you to decide ! before... proceeding test your wiring ECU TO IAT for loose connections frayed wires broken wires sensors are frequently a variable resistor that fluctuates according to conditions or position (ex: TPS) or... simple on-off devices that...
  2. C

    2001 evinrude 4 stroke wont run over 2900 rpms

    see link on SUZUKI fault codes https://powersportsguide.com/suzuki-outboard-fault-codes/
  3. C

    2001 evinrude 4 stroke wont run over 2900 rpms

    not to familiar with pre ETEC versions ...try searching UTUBES. some JOhnson were Suzuki made ...
  4. C

    2001 evinrude 4 stroke wont run over 2900 rpms

    check your PM in a few minutes go to the small enveloppe top right to find personnal messages
  5. C

    2001 evinrude 4 stroke wont run over 2900 rpms

    get the watre flowing check engine temps !! several sensors can keep you in SLOW mode
  6. C

    1968 Evinrude 5HP Angler will start after a few pulls and run anywhere between 2 and 10 minutes then shut off.

    if you hand pump to keep the carb full the fuel pump needs a close look at or replacement... did you at least unscrew the pump cover and check if the screen #15 is clean ??
  7. C

    Water pump 2011 Evinrude Etec, 75hp

    why not ask the folks here at IBOATS or a local dealer visit the E-TEC owner's board https://www.etecownersgroup.com/latest
  8. C

    1996 Johnson gearcase

    old is only a false perception of the young...they eventually change their minds. :-) 1949 version myself.
  9. C

    System check codes

    check u tubes ...ask for suzuki trouble codes could be just a warning or maintenance reminder
  10. C

    1986 Johnson 70 not charging

  11. C

    ‘06 Johnson 90HP Saltwater Won’t Crank

    it is a simple process of determining if the spark can jump across an air gap of 3/8"...using this tool allows you to do that when insaled between the plug boot and the clip on ground (engine frame)...
  12. C

    1986 Johnson 70 not charging

    looks like a simple full wave 3 wire rectifier tons of them on amazon if your want to rig or try one up for a few dollars. 2 yellows get the AC .. the red +goes to the selenoid...incoming battery wire the negative -_ pin goes to ground just bolt it up. here is one...
  13. C

    Impeller Replacement 66' Johnson 40hp

    when you find an interesting...whatever on the web go to the top row where the HTTPS:.... bla bla bla is located at the left most of the HTTPS.... row left click/hold the mouse Drag across the https al the way to the right to highlight the URL click the right side of the mouse andthen...
  14. C

    System check codes

    how about telling us what engine - year and mdl you have.
  15. C

    How to decarb an outboard?

    agree .................get the PH hot enough to evaporate any left over water inside the crankcase, rings & pistons.
  16. C

    1986 Evinrude water pump issue

    hence my request for a simple. if short duration lake test to properly submerge the pump but....
  17. C

    1964 9.5 evinrude

    there is realy nothing special aout about sealing the 9.5 GC and lots of utubes available to show you here are a few the tricky part is the shift shaft seal but utubes explain all that just be precise with the spaghetti seal butting properly
  18. C

    1986 Evinrude water pump issue

    impeller height the same as the impeller cavity height ?
  19. C

    How to decarb an outboard?

    gents, I understand the fear of destroying an engine with the technique of spraying water :-( but....engines do survive much more than just a small misty spray when they go for a dip overboard. In fact the technique for saving a swimmer is to drain the water and get the engine running...
  20. C

    1986 Evinrude water pump issue

    suggest you assemble the thing and try a lake run... forget the rest till you do a real run
Top