Search results

  1. Scott Danforth

    Force clamp screw bolt thread size?

    3/4" threads are most likely 3/4-10
  2. Scott Danforth

    New floor in fiberglass - rainwater drainage?

    your in-floor hatches will be below the water line you will have to build them like you build livewells and have a pump for each one. to keep your deck self bailing, you will need to make the hatches water-tight. I dont know your particular boat, however most boats do not have a lot of room...
  3. Scott Danforth

    Air Pump

    if you are going to put a compressor in the bilge, it needs to be SAE J1171 compliant so you dont blow your boat up. the issue with any on-board system is going to be how much volume of air you will have. anything that is 12 volt is not going to have a large tank. Not sure there is a solution...
  4. Scott Danforth

    2015 Four Winns fuel gauge

    Most likely corrosion or bad connection at the tank sender. Check there. Check continuity of the pink wire
  5. Scott Danforth

    Mercruiser 5.0 starting problem

    Battery voltage? Check the cables for corrosion Check voltage at the starter (both the B terminal and the S terminal)
  6. Scott Danforth

    Temperature Sender?

    Links to sensor manufacturers in the electrical forum stickies Look at the SMP (standard motor products) catalog
  7. Scott Danforth

    1985 Bayliner floor and under problems

    Floor is always the last to rot. Fiberglass resin has a shelf life of 6 months
  8. Scott Danforth

    2006 Sylvan Mirage Tri Pontoon

    What color wire is on the switch. Wire colors are standard
  9. Scott Danforth

    "FREE"19' Manatee!

    Free boats usually become the most expensive boats
  10. Scott Danforth

    Milky fuel in carb intake force 85hp

    What was the temp you were boating in? Do you have a fuel/water separator filter? Most likely you were boating in cold weather with water in your fuel
  11. Scott Danforth

    1985 Bayliner floor and under problems

    First, welcome aboard Second, free boats are the most expensive because they need everything repaired or replaced Third, go to the restoration forum. 4th sticky is the DIY information. Read links 14,15,18,2,3,4a, and 4b in that order Forth, the floor rotted long after the transom and...
  12. Scott Danforth

    330 black scorpion low power

    What are the compression numbers? Check your neutral safety switch
  13. Scott Danforth

    Home plumbing lesson learned.

    Recently replaced a 5mm ID 16mm OD seal on the dish washer that leaked enough to damage the floor Glad you found the leak. My next upgrade will be flow fuses
  14. Scott Danforth

    winterization procedure

    Follow the factory service manual. Drain everything first before you add antifreeze with a funnel https://forums.iboats.com/threads/winterizing-inboard-and-i-o.770207/
  15. Scott Danforth

    Please somebody indentify my boat

    So you do not have it registered in your name.... therefore it legally isn't yours
  16. Scott Danforth

    Blown head gasket

    Build a stroker if you want to keep RPMs low. Or let the motor sing like it should
  17. Scott Danforth

    Astroglass 1989 full rebuild

    Micky, you close to splashing yet?
  18. Scott Danforth

    aquasport 175 osprey

    Micky, you close to splashing yet?
  19. Scott Danforth

    2023 Splash of the Year Nominations!

    Only near splash ready restorations I am aware of is @mickyryan two restorations and the following from @DenisP https://forums.iboats.com/threads/1957-canadian-challenger-rebuild.769691/ None splashed yet
  20. Scott Danforth

    Clutch Fan to Electric Conversion, 1997 Suburban

    Did you get a new fan clutch? If so, just cut the old clutch off the waterpump
View older results
Top