Search results

  1. R

    1972 Chrysler 85, Tolletson carburetor tuning

    No need to " mess " with these .---Just adjust them according to how the motor reacts.-----Right at the top is the low speed mixture screw.----Set all 3 at 1-1/2 turns out from gently seated.----Adjust as needed with boat / motor idling in the water in gear.
  2. R

    1976 to 1987 lower unit swap

    I thought the switch from HYDRO-ELECTRIC occurred during the 1975 model year.-----Are measurements of the driveshaft length different ?-----
  3. R

    1972 Chrysler 85, Tolletson carburetor tuning

    Picture of front of carburetor.----Low speed mixture screw is usually near the top.
  4. R

    1972 Chrysler 85, Tolletson carburetor tuning

    Post some pictures of your carburetors.
  5. R

    Johnson 9.5 wont start in neutral.

    Hurry to--------leroysramblings------A place that covers almost everything you need to know / learn about these simple motors.----I need to step aside here.
  6. R

    Johnson 9.5 wont start in neutral.

    How did the motor run for you last season ?----Does spark jump a gap of 1/4" or more on an open air tester , yes or no.-----Have you had the flywheel off to inspect coils / breaker points / condensers , yes or no ?
  7. R

    Johnson 9.5 wont start in neutral.

    Does spark jump a gap of 1/4" or better on a test device.-----Not some blinky inline tester ???
  8. R

    Johnson 9.5 wont start in neutral.

    Did you remove the high speed jet screwed into the float bowl for cleaning ?------Checked the reed valves ?
  9. R

    Johnson 9.5 wont start in neutral.

    Compression is good.----Spark is good.-----Next thing to do is clean the carburetor.
  10. R

    Johnson 9.5 wont start in neutral.

    You should always start the trouble shooting with the basics.----Post the results of a compression test here.----Does spark jump a gap of 1/4" or more on a test device , yes or no ?
  11. R

    1989 88spl idle adjustment

    At idle the carburetor throttle plates must be closed.-----Idle speed is controlled by timing.---Not to be confused with MAXIMUM timing as that is not adjusted.---So turn adjusting screw in to speed up the RPM.
  12. R

    1989 88spl idle adjustment

    Are you pushing the key in and holding it in while cranking it over to start it ?----Are the high speed jets found in the bottom of the float bowl clean ?
  13. R

    Force 70 hp questions.

    Simplification.----Use your garden hose to fill a bucket with water.-------Once bucket is full you close off the end of the hose.------The water in the bucket is not under pressure from the hose is it ??
  14. R

    Vro alarm e70tlcur

    Does the tell tale hose come off the side of the block or off the top ??----Post the compression test values here.---Did you look into 0432955 water pump hit ?----It has parts / instructions for this motor.
  15. R

    1989 88spl idle adjustment

    Stop-------Timing does not normally go out of adjustment on these motors.-----How did this motor run for you last season??-----Does spark jump a gap of 3/8" on all leads , yes or no ?-----The orange wires going to the coils , what color stripe is on them.----Post each one 1 through 4.----And...
  16. R

    Force 70 hp questions.

    Really------Once the fuel goes past the float valve it is no longer under pressure from the pump !!----I am going to be blunt and suggest you find some videos on U-tube to see how a carburetor works.----Some videos are better than others.
  17. R

    1994 mercury force 70hp

    Open low speed mixture screw (s ) about 1/8th turn at a time and test run.
  18. R

    1983 black max 150 running poor

    Start motor.----Pull one plug wire off at a time.-----Note the response of the motor.-----Report the results here.
  19. R

    '78 Johnson 75HP will not return to idle.

    Some of the 75 HP models used a 2 cylinder gearcase.----That is why there is a different gear ratio.
  20. R

    Evinrude 25 - Part Missing

    The motor looks like brand new.----Should be interesting thread on this when you get it running.
Top