Search results

  1. alldodge

    1995 Stingray 4.3L Mercruiser No Start

    Its a Mercruiser, it has a slave solenoid The boats motor wiring is what's above Here is the helm wiring
  2. alldodge

    2016 Mercruiser 4.5l Shift Interrupt switch

    Again need motor serial number
  3. alldodge

    3.0L I/O issue after new shifter was installed

    The shift cable is not adjusted correctly. Most likely the shift interruptor is switching and causing the motor issues
  4. alldodge

    Merc 4.3 in a 2006 Maxum SR3 1800. Will crank, won’t start. Seems to be fuel system related…

    12V direct is of no issue, just connect +/- correctly and it should power up
  5. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Yep, I brought up the thread in 3 windows. Port, Stbd and my comments
  6. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Oh well, just blew that one STBD 13.1 and 12.0 problem child low voltage PORT 12.9 and 11.9 STBD has misfires 1, 2, 8 CAT temp 200* higher Less fuel ms and more degree timing Idle set 600 Port idle set 636 That's all I got, hope @muc might see something
  7. alldodge

    2016 Mercruiser 4.5l Shift Interrupt switch

    What is the motor serial number?
  8. alldodge

    Merc 4.3 in a 2006 Maxum SR3 1800. Will crank, won’t start. Seems to be fuel system related…

    You got the right method and your down to the pump. You did say it was getting 12V, and if it is check the ground. If the ground is good, pull pump and bench test
  9. alldodge

    Old Boater Collections

    Its not folks, edit and remove please use PM's
  10. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    My heads starting to hurt port 81 - motor is running stbd 78 - motor in not running I'm trying to compare apples only
  11. alldodge

    1995 Stingray 4.3L Mercruiser No Start

    Assume a carb motor Wiring is for a Bravo, if you have an Alpha the interruptor goes between the Dizzy module to Ground
  12. alldodge

    2016 Mercruiser 4.5l Shift Interrupt switch

    Idle Air Control valve. Its what the computer ECM uses to control idle rpm. It can get gummed up or just go bad. Doesn't happen often but can happen. If it goes out completely you have to give it throttle or it will die
  13. alldodge

    2016 Mercruiser 4.5l Shift Interrupt switch

    It could, and it is adjustable Could also be the IAC is starting to stick/fail. Is the idle smooth and at what RPM, and when it doesn't stall does the RPM stay steady?
  14. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Maybe you already posted it, but what does the Port engine show with Diacom connected at the Port engine like you did with Stbd?
  15. alldodge

    2007 Rinker electrical issues

    I think Marina connected something wrong and don't want to admit it, because they don't want to pay to fix. Electronics are sensitive and a split second of reverse wiring, kills things Look real close around the Bats and see if any of the cables or wires have burnt spots on them. Does the...
  16. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    STBD 12.8 and 11.5 PORT 12.9 and 11.9 What is the Diff at the Port Engine?
  17. alldodge

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    I'm on the other side of that one. Motor running Helm it shows 12.8 system and 11.5 Bat Engine 13.2 Ignition 12.15 Bat
  18. alldodge

    Trim cylinder rebuild - Seized inner pin (closest to transom)

    Rent one from local auto parts store or maybe even home depot
  19. alldodge

    how to lift new 5.7 motor with edelbrock manifold

    Full dressed 502 and two 1 inch lifting straps
  20. alldodge

    Trim cylinder rebuild - Seized inner pin (closest to transom)

    My question is why do you want to try heat First? Try a puller first
Top