Search results

  1. alldodge

    Re-upholstery Job on Cruisers Yacht 338 Bowrider

    Great craftsmanship
  2. alldodge

    Maybe my turn for new boat time

    Good deal thanks
  3. alldodge

    Maybe my turn for new boat time

    Lots of boats and have just a few pics,maybe post later this eve or tomorrow. Cost are up higher then when I just looked a few days ago. In Englewood now and going to salt springs later
  4. alldodge

    Chaparral backfiring a lacks power

    Might be fuel pressure
  5. alldodge

    Re-upholstery Job on Cruisers Yacht 338 Bowrider

    Looks great
  6. alldodge

    LED dash lights for a 2016 Four Winns H190?

    No issue other then if you want to dim it
  7. alldodge

    350 Mag couplers 18643A5 or 18643A7

    Don't think of it as a conversion kit, it's just the latest revision of the part. The number after the "A" is a revision indicator which can mean its using a different manufacture or there was a slight improvement to the part. Using the old version or new version are interchangeable
  8. alldodge

    Second fuel tank

    Don't know how good the fuel pump sucks, but think your looking at doubling the amount of fuel that would need to lifted do it. I'm seeing a single 1/4 inch fuel line going to 1/2 after the Tee. This means it has to pull twice the amount of fuel up. They will probably stay the same level...
  9. alldodge

    Bravo3 detent

    The shift cable should move easy with motor running. With cable disconnected from the shift plate, you should be able to shift drive with your hands just by moving the cable. If it shifts easy this way then check the throttle handle and cable to shift plate. If it doesn't move easy then its...
  10. alldodge

    What is this sound on Mercruiser 4.3, Alpha One?

    Plug wire arcing, exhaust flapper, maybe flywheel dust shield is loose
  11. alldodge

    Chaparral backfiring a lacks power

    When asking a questions its always best to list the motor serial number The dizzy connector is a cam sensor and is not used on your motor. Measure fuel pressure at the rail, 43 psi Also replace the dizzy cap and rotor Being a 2016 means you have CAT exhaust and most likely the motor is in limp...
  12. alldodge

    Tune up info

    Thanks You have a TBV ignition no points and non-vortec motor Plugs AC Delco MR43T or Champion RV15YC4 This is a link to your motor and parts breakdown https://www.mercruiserparts.com/350-mag-alpha-4-bbl-gm-350-v-8-1996-1
  13. alldodge

    2003 Ebbtide Mercruiser 3.0 engine rattle? Normal?

    Look at the idle adjustment screw on side of carb where the throttle cable is connected. The marine carb doesn't have a return spring, the cable is what moves it to idle. Take the cable off carb and then adjust idle screw. Once its down, adjust cable barrel is it just slides on , remove...
  14. alldodge

    2004 5.7 Thunderbolt turns over but won't start

    See if the cap contacts are clean and not corroded, and pickup is clean
  15. alldodge

    Tune up info

    Always list engine serial number so folks know what your working on. Being a 96 model it should be a TBV ignition. my 95 has one but its a 454. Look at the dizzy cap and rotor, and while many say to replace plugs, I replaced mine a few years ago for the first time and they still didn't need...
  16. alldodge

    Maybe my turn for new boat time

    Probably has to be new, but just noticed the 310 CBR is being built with OB. Std is 300 and can go up to 400R. Has vac-u-flush pump out head and anchor windless, so its in the mix.
  17. alldodge

    Maybe my turn for new boat time

    Caveat, so long as the boat is under 6K lbs, right ?
  18. alldodge

    Maybe my turn for new boat time

    Have always say never say never. But I never plan to own a boat that I don't haul my self. NO change here on the new ones were looking at
  19. alldodge

    Maybe my turn for new boat time

    I have looked at the RS30, and not bad, an upclose will help
  20. alldodge

    Maybe my turn for new boat time

    Yes, and correct if I misunderstood. Its a shuttle that runs between the different sites of the show. The stuff we want to see is at the convention center. I looked at parking but did not see openings closer to the other places
Top