Search results

  1. alldodge

    5.0 Litre GXI Going Into Limp Mode

    JB might be 2 different boats. The CATs didn't start till 2014 for Merc, assume VP would be similar
  2. alldodge

    5.0 Litre GXI Going Into Limp Mode

    What codes are you getting?
  3. alldodge

    1900 2006 Regal Ignition

    That isolator doesn't even look wired correct What motor you working on?
  4. alldodge

    Engine starts and dies.

    Bummer, but good to know what the problems is
  5. alldodge

    93 Maxum 4.3 timing issue

    Both serial numbers use the same lock nut https://www.mercruiserparts.com/850093-nut
  6. alldodge

    How is capacity plate attached?

    You can attach it anyway you want, there is no requirement that I've ever found. Use screws or other fastner
  7. alldodge

    Adding a House Battery to Bayliner VR5

    The size cables/wires to use depends on what will be connected to it. Using just what is listed so far, I would use 10 gauge wire, Run a Red and Black from the new battery to a new fuse block. Then connect the VHF, radio and other to it. Your current black wire probably goes up to the current...
  8. alldodge

    Normal rust on 2011 Mercruiser?

    Normal, will take a very long time for that to become an issue.
  9. alldodge

    93 Maxum 4.3 timing issue

    I'm confused also I adjust valves by watching which valve is open. If a rocker is opening a valve I do the other. It might take more turns, by I know the other is fully closed
  10. alldodge

    Tilt and trim

    Yes, twisting the wires together bypasses the limit
  11. alldodge

    93 Maxum 4.3 timing issue

    The tag on the block is the one to use so it is a 1993 motor (not 93 and up). Don't use the 0F that is for a 96 to 97 It does use zero lash (so up/down) and then 1 full turn
  12. alldodge

    Impeller housing overheating

    A hard stop is electrical Conversion to electronic I would suggest Delco EST
  13. alldodge

    5.0 GXi Rough Idle

    Where did you get the injectors? Has the motor been scanned for codes?
  14. alldodge

    VP 5.0 to 5.7 high idle

    The good thing is having MEFI's they can be reprogrammed by many. Can even be done by yourself with MEFIBurn software, and AFR meters
  15. alldodge

    2007 350 Mag Not Pumping Water

    Well you did say Inspected So have a good look
  16. alldodge

    2007 350 Mag Not Pumping Water

    The hose can get twisted and kinked but being a dealer did it , its not to likely. In any case look at the hose going from drive bell housing to transom assy and see if it is
  17. alldodge

    Merc 5.7 Q Jet fueling issues

    Check your gas tank vent line. When it bogs down, open the gas cap and listen for air being sucked in. If that does help Check your antisiphon valve on the tank that the rubber fuel line is attached and goes to the filter. The valve can get crud build up and need replacing Can also get a...
  18. alldodge

    93 Maxum 4.3 timing issue

    Not knowing the serial number, and assuming motor is a 1993 Valve lash is fixed, torque to 20 FT LB and your good. No up/down to mess with
  19. alldodge

    3.0 Timing Question

    Yes, the module controls timing, but I would test all components in the distributor before replacing it Do agree just run it, it should be fine and recheck later
  20. alldodge

    3.0 Timing Question

    BTW, does the motor label list 2ATDC?
Top