Search results

  1. alldodge

    2002 Regal 2860 Commodore Listing Starboard

    Most all single engine cruisers list to starboard (mine also). The head is on the starboard side and the water tank is on the port side. If the water tank is filled, this helps right things a bit, but may not do it all. I don't worry about it, trim tabs flattens things while running Edit...
  2. alldodge

    Johnson 7.5 Kill switch troubleshooting

    Have you checked continuity of the Black/yellow all the way to here it goes?
  3. alldodge

    357 mag bravo 4v long block replacement

    The Merc 357 4V is a remanufactured 350 which has been bored. In short reman 350 vortec
  4. alldodge

    Vessel View Installation

    Good to hear, what was done to get it going? Can help others
  5. alldodge

    Am I crazy

    Pontoon not so much for waves Merc 375lb and Suz 416lb = 41lb difference
  6. alldodge

    Am I crazy

    Agree bad idea for another reason, the increased weight of the 4 stroke will slow you down. The added weight on the stern can also cause water to come in during a wave in because it sits lower Example of weight and speed Had a 205hp 4 dtroke seadoo and a 155hp 2 stroke seadoo, they had...
  7. alldodge

    Cutting cable TV

    It looks promising but also folks are saying use a VPN because not sure where its coming from They also recommend using bitcoin to purchase
  8. alldodge

    2020 Splash Of The Year nominations

    Scott's Rogue
  9. alldodge

    1992 Mercruiser 4.3L 262 CID Pre-Vortex Back Fires

    Just rebuilt, I would think valves. Assuming its a 1992 Valve lash is one additional turn after zero lash
  10. alldodge

    Wiring help for a 2009 Tohatsu MFS20CEPTL

    Starting on page 25 there is a wiring diagram https://www.tohatsu.com/tech_info/own_man_pdfs/Toh60C_70C_90A_120A2_140A2.pdf
  11. alldodge

    wellcraft not charging

    Agree Mando ALT This would be your wiring
  12. alldodge

    Johnson 7.5 Kill switch troubleshooting

    2 stroke Will run if the black/yellow is NOT grounded Will not run if black/yellow is grounded
  13. alldodge

    Johnson 7.5 Kill switch troubleshooting

    Should only see continuity if the motor is turned OFF or kill switch is pulled The power pack is grounded to kill the motor, and open to start it
  14. alldodge

    GM350 TBI hesitates when accelerating fast...

    Motor should be running and DLC without a jumper. Once normal operating temp is reached, place jumper in DLC without stopping the motor. with motor is base timing mode, adjust timing to 8 BTDC. With timing adjusted and motor still running, remove jumper from DLC...
  15. alldodge

    Charging issue?

    Yes it was posted after this one. Appears the OP took my advise.
  16. alldodge

    Alpha 1 Gen 2 Vertical Play

    The trim cylinder have replaceable bushings item 14 https://www.mercruiserparts.com/bam/subassembly/30862/2686/180
  17. alldodge

    Alpha 1 Gen 2 Vertical Play

    The up/down play comes from top and bottom pivot pins, and bell housing and bell housing pins. In most cases its the top and bottom steering pins and bushings
  18. alldodge

    Alpha 1 Gen 2 Vertical Play

    Are you saying the you can grab the lower unit and move the whole drive about an inch?
  19. alldodge

    Charging issue?

    Seeing numbers that high means the regulator is fired. Your actually seeing AC volts and not DC. Need to post this in the Evinrude section to get the outboard guys involved
  20. alldodge

    Alpha 1 Gen 2 Vertical Play

    What part of the drive has an inch of play?
Top