Search results

  1. R

    82 Johnson trim

    Sorry.-----I am asking you to provide information so that you can get help.----Earlier trim motors had 3 wires and later ones had 2 wires.-----I can not see what you have !
  2. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    But we are asking you if spark will jump a gap of 1/4" on a test device.-----Not whether spark jumps the gap on a plug laying on the block.-----You may not know or understand the difference and how important it is.----Sorry.
  3. R

    evinrude carbs

    There is an issue with the float or float valve.----That is why one carburetor is leaking !----What port connects to the top ?-----Pictures needed so we understand what you are talking about.
  4. R

    82 Johnson trim

    Your trim tilt may well be an older unit.----So does your trim m0otor have a blue and a green wire ?----Or blue , green and a black wire ?
  5. R

    7.5 Mercury Outboard Trouble Starting

    I mentioned crankcase compression !!----I made no comment about the compression test in the cylinder.----Perhaps this is your first stab at diagnosis of a 2 stroke engine.----Time to read up on the basics.----Sorry to be so blunt here.
  6. R

    1963 10hp Johnson QD-24 Flywheel rotating the mag plate

    Sounds like it might be running on just 1 cylinder.----I can't see, hear or feel your motor.----What are the compression numbers ?----Checked fuel pump diaphragm ?----Does spark jump a gap of 1/4" or more on a test device ?
  7. R

    7.5 Mercury Outboard Trouble Starting

    Oil / gas collects at the bottom of the motor.----The bleed hose returns it to the top of the motor.----You must have that in service.----Perhaps there are issues with crankcase compression.----Upper and lower crank seals.----Reed valves. ----And labarynth seal between the 2 crankcases.-----
  8. R

    Can't get the remote control open

    They will work just fine !
  9. R

    lower unit

    Start with a compression test.----Post your numbers.----Follow that with a spark check.----Spark must jump a gap of 3/8" on all leads.----This does sound like the BOAT theory ( bring on another thousand ) is coming to my mind.----Perhaps you now understand why this was for sale.-----Lots of...
  10. R

    lower unit

    Prop hub slipping ?---Try another prop.
  11. R

    76 6 horse long shaft . Special instructions

    The copper tube must be installed in the exhaust housing first.----Then you can see and guide the tube into the pump outlet !!
  12. R

    7.5 Mercury Outboard Trouble Starting

    I can not see, hear or feel your motor.----The recirculation system is needed.----What bunch of parts did you replace ?-----Water pump impeller was replaced hopefully.-----Steps you need to take.------Post the results of a compression test.-----And does spark jump a gap of 3/8" on a test device...
  13. R

    1982 wellcraft V20 renovations

    Had a V-20 Wellcraft 25 years ago.---Twin 115 HP.-----Wish I still had it.-----But today that boat will likely need full restoration.
  14. R

    Buy a boat with a bad starter?

    I reluctantly installed a motor on a 40 + year old boat.-----Had nice paint job .----New travel cover.---Seats redone etc , etc.----Bolts for motor would not tighten as transom was squeezing together.---Other signs of rotten wood under the floor.------Novice owner is delighted with his...
  15. R

    Buy a boat with a bad starter?

    It simply means-----" The motor can not be started today "-----You pay your money and take your chances.
  16. R

    Remote Control Cables

    Without pictures it is hard to say.-----Is yours a " powershift II " control box or the later slim control box ??-----Any part # on the old cables ?
  17. R

    Tips and advice for repairing outboard head gasket

    The head is warped.----They all are.----Refinish it with emery paper on a flat surface ( piece of glass ) before installing.
  18. R

    76 6 horse long shaft . Special instructions

    The roll pin at the top is important.----It drives / spins the mechanical seal under the power head.----Keeps water out of engine.------Copper tube MUST be installed in the exhaust housing before installing the lower unit.
  19. R

    Lower unit gearbox

    Your location ?-----Rebuilding is not likely possible due to the price / availability of new parts.----A donor motor is the best choice if you have time to look.-----Want to go boating next week then the BOAT ( bring on another thousand ) will apply.
  20. R

    What is this piece from my remote control

    Now I can tell.----You are correct on that part.
Top