Search results

  1. alldodge

    5.7 Mercruiser EFI, idle after warmup quits engine

    Agree most MPI's fuel pressure is higher but according to manual 24 it shows 30 psi at 1800 rpm. Have been wrong before and maybe this is another time, but... on the Mercruiser website I find under serial number 0M033393 in the listing below and it shows the following listed below
  2. alldodge

    Chrysler ignition switch

    Being a Chrysler motor see if Frank Acampora may assist it should be pretty standard. This one should work, but wait for others to double check. http://www.iboats.com/Sierra-Ignition-Switch/dm/cart_id.356033800--session_id.206272045--view_id.47122
  3. alldodge

    454 bracketry clearance

    Valve covers were different in 88-91 then 92-96 In 96-97 roller cam Exhaust elbow are the same from 88-97, (bulletin in 92-96) maybe further didn't check Carb linkage same from 88-96, change to stamped steel after but basically the same Shift bracket all the same Is see there may be an issue...
  4. alldodge

    03 9.9 kicker

    It's similar to a harmonic puller, just smaller. Don't know how handy you are, but I would make one. Find a grade 8 fine thread bolt and nut. Get a piece of 1/4 inch steel and drill a hole in the center for the bolt, and three smaller ones for the bolts which screw into the flywheel. If you have...
  5. alldodge

    Wood burning Fire place conversion

    Have decided to seal off both fire places and make them vent free propane. Looking into two possible conversions so far; Close the dampers and go to the rook and pour some gravel down, cover the flew and install gas logs Close the damper, cover flew: Install an insert, then add logs get...
  6. alldodge

    97' Kayot Ultrastar 262 mag acceleration problem

    Need a paper clip and an LED with built in resistor, or can buy a ready made. When the key is turned to ON the light will flash, then a pause, then more flashes, then longer pause followed by more flashes if more then one code. Count the flashes
  7. alldodge

    Where to find a 2001 Yamaha F 15 eshz Yamaha wiring diagram

    Haven't been able to find the wiring diagram but here are the color codes http://www.maxrules.com/fixyamahawiring.html
  8. alldodge

    Houseboat wiring dilemma

    Being an 88 it might not have start switches. Would help if you could provide the wire colors on the switches. Still thinking one momentary switch would be the horn, as for the other two would help with wires attached. Below pics are for Mercruiser but wiring should be close
  9. alldodge

    Advice on rot!

    Have to agree this is not going to be pretty. Hope you got it for free, or you really love boat because what I'm seeing it appears the entire hull is going to need to be stripped out. For the most part take it down to the bare hull and start over. May need to look like the one below before...
  10. alldodge

    Houseboat wiring dilemma

    Howdy Unable to find a diagram for your motor but found one which should help with the color scheme, "maybe"
  11. alldodge

    House Battery charging question

    From what I can find it will help but the Gen will not put out enough "IF" the batteries need no more then 4.6 AMP (80% load) from the Gen to keep the batteries charged. Your charger (model TC4012) can draw up to 7.7 AMPs. There is always efficiency loss when changing from DC to AC or the...
  12. alldodge

    1995 Searay 400 express cruiser - maintenance advice requested...

    I would recommend replacing the pickup. Don't know if it was damaged by hitting something or by loading on a trailer incorrectly. Remove the hose and seacock, and ground wire, then remove the nut. After that it will take some doing to get the fitting out. Clean are repair the hole, including...
  13. alldodge

    72 Thunderbird Formula w/twin 165hp Mercs

    Here is a pic of my old trailer, which also resembles my new and also my Rinker trailer
  14. alldodge

    safety chain plate for light trailer...

    Have a few ideas: If you can find a ball with long shank, just drill a hole thru the center and bolt on. If there is a place under the bumper that this plate could be welded to or a shackle Have any place you could wrap a piece of chain around the rear? I guess you don't want to drill two...
  15. alldodge

    Residential wiring question.

    The thin GFCI outlet are only about 3/8 inch thinner and 15AMP compared to standard 20AMP
  16. alldodge

    Best way to move dirt?

    I'll keep looking but this is my last try for a visual. Image on the left is just look sort of straight but front board is lower then back. Keep in mind just an illustration, boards are flat and level to one another. Image on the right shows land slope on the bottom in orange. The green pole...
  17. alldodge

    Best way to move dirt?

    Hope my second post clears it up for you. This works at any distance, even a mile away, but may be to much for under 30 foot
  18. alldodge

    Best way to move dirt?

    No, much easier. They used this method to lay out the aqueducts over many miles
  19. alldodge

    5.7 has spark question

    You saying you have spark, just maybe not good spark. Since your getting spark I don't see it being a distributer issue. Check for spark by pulling the coil wire off and see if it comes steady, if it is steady I would go back to the fuel side. Even a weak spark will set off gas unless your...
Top