Search results

  1. R

    71' mercury 115 inline 6

    Remove bypass cover ( middle one of 3 covers ? ) and inspect piston and rings.
  2. R

    water coming out carb

    Gasoline needs heat to evaporate.------It gets that heat from the carburetor body.------Carburetor will be cold.----You might be looking at condensation.
  3. R

    50473m 50hp evinrude lark ignition wiring diagram

    There is a 20 amp fuse ( 5/8" long ) in a wee black rubber plug in.----Find it near the starter solenoid.------Note , this engine does not need 12 volts from the battery to make spark.
  4. R

    Head gasket orientation 1990 4hp E4RESR

    That rubber hose is NOT a " metering rod " at all.-----It merely guides cooling water around the engine.------Water does NOT flow through that hose either.----A product called ---LUMIWELD -----can be used to repair that defect.
  5. R

    1980 70hp Evinrude clatters and hard to get into Forward gear

    Have a shop start by setting the shift rod height.-----If you keep running like this you will destroy the lower unit gears/ clutch dogs.
  6. R

    Water in oil

    A 4 stroke with water in engine oil.
  7. R

    1990 45 h. comm. tiller w/rope and elec. start

    Many folks did install electric start.------Most of those electrical parts have the part # on them for you to check.
  8. R

    1988 Merc 200 HP Smoking during warmup.

    I have said it many times.------Mixing of oil / gasoline , 2 stroke engines , lubrication is just not well understood.-----This thread is proof once again.
  9. R

    Part identification

    Looks like part a new stator " upgrade " kit.
  10. R

    4 HP Evinrude Coils

    Any pictures of these coils ?----Where are the coils mounted ?
  11. R

    79 35hp evinrude wet plugs

    Plug wires are on wrong cylinder or issue with flywheel key.
  12. R

    Newly bought Johnson 7.5

    ??----Are there not 2 screws 1/4-20NC thread at the top ??-----Model # of your motor ?
  13. R

    Losing a cylinder intermittently ‘86 50hp

    What number is on your fixed air jet in your carburetors ?----What elevation are you running at ?
  14. R

    Newly bought Johnson 7.5

    Fact----You remove the 2 small screws at the top of the recoil starter.----Have your assistant lean the starter out of the way .----Then remove the 2 nuts to get the carburetor off.
  15. R

    2 Stroke Oldie Evinrude.-

    As per post # 25 I would say.
  16. R

    Is trigger supposed to wiggle?

    Does the motor run properly ?
  17. R

    Losing a cylinder intermittently ‘86 50hp

    Smooth surging is usually a fuel issue.--Water in the fuel ?--Try running with a different fuel tank and hose.------Run with a timing light to see if perhaps spark has issues.
  18. R

    What would you put in a small outboard repair kit?

    Little Current and Killarney area.
  19. R

    What would you put in a small outboard repair kit?

    Look into a 24' freighter canoe.----Carry everything and everybody.-------Talked to some folks that go a week at a time with a couple of them in and around the famous ---" North Channel ".-----Captain said that most folks are amazed how fast they go with 10 paddlers / canoe.
  20. R

    What would you put in a small outboard repair kit?

    In practical days long gone , they used 19 cent shear pins.----But you had to put up with the inconvenience , had to have spares and tools.------OMC went to steel drive pins that did not shear.----Mercury went to splines and called it shear proof drive and that feature sold a lot of...
Top