Search results

  1. C

    Evinrude outboard year

    post picture of the plate cleaned up
  2. C

    battery charging issue has me stumped

    All good suggestions yet OP said 0 ohms measured from rectifier output to batery end of the cable . I asked several time to clean all connection points ....across the solenoid In telcos whenever we had green death on cable pairs joints/splices a good shot of DC 130v fromthe CO. would...
  3. C

    battery charging issue has me stumped

    here is another option ... remove rect/reg . test stator specs for your engine if stator ok and generates AC hook up the stator AC source to cheap amazon full wave rectifier direct connect the Amazon unit to the battery and check for volts going up with rpms if your's is a 3 phase...
  4. C

    battery charging issue has me stumped

    check your VOM most can handle 10 amps dc curent unless your's is a small .. very basic version .
  5. C

    What starter gear?

    here is one option... parts look-up for a 1980 25hp electric start shows..... 11.... :)
  6. C

    1978 Johnson 85ML78C

    I do not have a blaster unfortunately and althought I do agree on the potential of rendering a plug useless I have across 50+ years ...done so with no apparent ill effects by simply not being overly agressive on the plugs. A small SS brush works to.... followed up with a wash of...
  7. C

    battery charging issue has me stumped

    yet at several posts OP says battery charges up fine, runs the starter fine and no apparent "voltage change" when hooked up to a different battery (lawn tractor battery) well in theory with RPMs current/volts should flow out of the stator/rectifier and to eliminate the battery " option"...
  8. C

    battery charging issue has me stumped

    by ohms law the disconnected end of the batt cable will be the highest resistance point of the cct so it is normal to see vols maybe not amps but volts only ! with the batt connected the highest resistive point is no longer the open air cable end work back to the solenoid and back to...
  9. C

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    don't forget 15% GST and Prov. taxes here it adds up to $190 hr. asking competitors to agree on raise prices also known as collusion....:-( aka price fixing. one local shop wanted $375 (plus 15% taxes) for fixing 2 inches of broken keel ... JB weld $10 not perfect but ETEC blue will...
  10. C

    E10RCNS 9.9 1982 evinrude lower unit seal kit

    ? sorry no pics
  11. C

    battery charging issue has me stumped

    how is the weather ?
  12. C

    1978 Johnson 85ML78C

    well those plugs could still work.. just polish them up on a wire wheel and carb cleaner , gap them reinstall them and get rid of the big anchor asap....
  13. C

    Revolution limiter

    mdl# hp?? manuf ? ficht ?
  14. C

    Trim problems

    have you or how have you determined it is faulty ?
  15. C

    battery charging issue has me stumped

    this is like groundhog day.... measure your observed voltage variations from point "A" where you say the variataionsare evident then all the way to the batt post B+ via the solenoid interconnect point post your measured values values and observed reactions to RPM changes per site of...
  16. C

    Trim problems

    see diag. Richard. btw your best place for ETEC problem solving (no offense) is the ETEC OWNERS BOARD forum where only ETECs are discussed. also has an excellent search utility https://www.etecownersgroup.com/latest
  17. C

    Trim problems

    are you referring to the trim upper limit switch that keeps the OB from raising further up ? that switch is simply a normally closed switch andallows the T&T to rise it mechanically opens the UP circuit feeding the UP relay since it is wired in series . AT the upper limit this stops...
  18. C

    battery charging issue has me stumped

    you have 2 yellows from the stator... they generatean AC voltage to be measured on the AC scale. across the 2 yellows. that said the rectified voltage on the RED going to the solenoid and eventually to the battery you say gives you a voltage (DC) swing according to RPMs when...
  19. C

    1966 Johnson 9.5hp (MQ-12A)

    leroy's site is shut down last I checked
  20. C

    battery charging issue has me stumped

    unless we get clear answers on suggested steps to clear out this problem the desired outcome will not be reached.
View older results
Top