Search results

  1. C

    1996 evinrude 70hp electrical issue

    hopefully it won't lown again otherwise you will need to find the cause .
  2. C

    9.5 issues

    are you confirming it idles ok with the hood off ?
  3. C

    9.5 issues

    links and carb adjusted ? is this a new problem or ... .a new motor to you ?? did it ever run good does it run ok at higher speeds above the ildle tried adjusting the side knob to up the idle rpms ??? have you adjusted the timing ??? what ohms value do you see between boots and...
  4. C

    1977 Johnson 75 Stinger dies when put in gear

    the orifice plug is just a hole" if you cleaned them they should be OK ... be focus on other stuff for now .
  5. C

    ELECTRICAL CONNECTOR TOOLS

    Most of those amp connector pins have small locking tabs. the idea is to insert a tool to overlap the locking pins ...sometimes one pin sometimes 2 pins! I have managed to extract some by flattening different size finishing nail by hammering them out on an anvil and grinding the...
  6. C

    1995 Johnson 130 No Power Under Load

    The carbs have been checked and cleaned.... ....it gets up around 2k rpm and fell flat on its face unless someone was priming the ball on the fuel line don't mean to be picky but exactly was done on the carbs. were all orifices cleaned and air blasted. the HS orifice plugs...
  7. C

    Battery sparking

    no offfense but.... I had a 9.5 hp as my side kicker for trolling... trolling which does not have to be at the other end of the lake all the time . I ran a 3 gal tank on the 9.5 ahd found that even trolling during several days was adding up at today'S 7-8$ Cdn per gallon (gas here today...
  8. C

    1995 Johnson 130 No Power Under Load

    2 years sitting....have you serviced the carbs ??? as a bare minimum have you cleaned out the High speed orifices the bottom of the carbs ...just behind the lower carb bolt have you checked all filters incl. tank pick up ??
  9. C

    What type of hydraulic fluid to use in '98 50hp Johnson? Replace relays too while I'm at it?

    btw my 75hp ETEC was doing the same.... in my case a T&T reseal was in order. been ok since :)
  10. C

    What type of hydraulic fluid to use in '98 50hp Johnson? Replace relays too while I'm at it?

    cylce the system a few times to purge any air...keep topping the oil after every cycle till 100% full
  11. C

    Looking for Service manual for 1982 evinrude 2hp (E2RCNE) outboard

    what compression #s do you get ... if OK don'T mess with it just do the top side stuff ! http://www.leeroysramblings.com/OB%20carburetor_repairs.html http://www.leeroysramblings.com/Troubleshooting%20OB.htm http://www.leeroysramblings.com/johnson_magneto.htm
  12. C

    Looking for Service manual for 1982 evinrude 2hp (E2RCNE) outboard

    not much to service on a 2hp what issues do you need the book for ??
  13. C

    Strange leak on 9.9 Johnson

    16mb file... !! I am not openning it.
  14. C

    AC lightning plug on Evinrude / Johnson outboards

    6 year old topic..... best to start a new one. search the net for parts 3 pin plugs are common some folks use solar panels to trickle charge their batteries
  15. C

    9.9 johnson outboard recommended oil?

    usual twc3 at 50/1 regular gear case oil see article below http://www.leeroysramblings.com/Johnson%209.9_15.htm
  16. C

    76 Johnson 15 HP

    if electricals are ok , compression is OK carb is clean then fuel combustion is inadequate either from poor delivery from the carb (TBD) or inability to pull the fuel from the carb due to vacum loss in the crankcase (seals) . can you at least feel a good pull of air on the carb face ?
  17. C

    76 Johnson 15 HP

    magneto cam arm and carb adjusted (synch'd) do you see the throttle and throttle pale reaching their maximum range ?any exhaust obstructions ? does it pick up speed if you shoot some fuel mix in the carb ?
  18. C

    76 Johnson 15 HP

    back to basics ... compression #s OK ???
Top