Search results

  1. C

    76 Johnson 15 HP

    i'll try...to remember
  2. C

    76 Johnson 15 HP

    I can never remember which is starboard... only left and right looking forward :) and I do not have to many years to learn so for me it stays left and right :) This is the transcript of a radio conversation of a US naval ship with Canadian authorities off the coast of Newfoundland in...
  3. C

    76 Johnson 15 HP

    the points that " open "at TDC of a piston belong to that piston...
  4. C

    76 Johnson 15 HP

    when one piston is at top dead center ....... one set of points should be open usuall y .020 or begin to open That cyl. the one associated with your , coil and plug wire and plug wire & point to find TDC (approx) poke a small screw driver in the sparkplug hole & turn the FW till you...
  5. C

    What to jump on old Johnson 65HP

    drawing is presumably for a 72 you have a 73 so expect small changes....or none
  6. C

    What to jump on old Johnson 65HP

    here is a 72... 65hp wiring https://maxrules.com/graphics/omc/wiring/1972_65_Eshift.jpg
  7. C

    What to jump on old Johnson 65HP

    engine model# ???
  8. C

    1959 Johnson seahorse 10hp qd-20 wont idle and need bracket

    qd 20 is listed as pressure tank engine unless modified....to pump.. assuming carb is clean and adjusted..... running out of fuel is indicative of loss of pressure to push the fuel back to the carb , hand pumping the primer button should confirm this as it will refill the carb filter...
  9. C

    69 9.5 Evinrude spuddering/coughing

    plastic plug... I would rebuild the carb as per design intent. pass as small 2lb mono in all orifices (channels within the carb) btw change the float if you have doubts or a spare one.... check for any missing lead plug in the carb body not much else you ca do.
  10. C

    69 9.5 Evinrude spuddering/coughing

    if electricals are OK, timing & compression is ok, throttle/carb synchronized .. side knob adjusted .... carb is dirty....did you use high pressure air blasts one option...change the tilt angle on the motor... one fellow I sold a 9.5 was having problems and noticed that running the...
  11. C

    69 9.5 Evinrude spuddering/coughing

    as per Leroy'S there is a small plastic gizmo plug #0312909 inside the LS circuit under the round plug did you or not... inspect all areas under the round plugs... change the plastic insert etc.... see part 1-2 on cleaning these carbs. from LEROY'S..... there is no aftermarket...
  12. C

    1999 Johnson 3 cy 35 hp overheating?

    start a new thread.. this one is 17 years old !
  13. C

    Oil dripping down over prop out of water

    https://forums.iboats.com/threads/1977-evinrude-25-oil-leak.761946/
  14. C

    69 9.5 Evinrude spuddering/coughing

    the side knob controlling the low speed limit may be to low .... turn it and see the throttle handle rotate to a speedier position towards SHIFT btw was this engine running so bad ?? to have you change plug wires etc.... was this a sudden issue or are you reviving an oldy ? did you test...
  15. C

    Rebuilding 1980 johnson 35 Cant split the case?

    now that was not so mean...seen a lot worse and it goes both ways. I am certain FR was just being funny. lets all use our nostrils more :-)
  16. C

    1977 Evinrude 25 Oil leak

    in 2 strokes when the dirty exhaust is pushed out the cylinders by the incoming load of fresh fuel-oil mix from the carb part of the fuel oil mix also passes out the exhaust ports and ends up with the fumes, carbon and sludge down towards the open world. In this case... your water...
  17. C

    69 9.5 Evinrude spuddering/coughing

    see adjustment how did you clean the car totally or partially ..?? is the float adjusted ok did you inspect and clean out the HS jet behind the bolt at the bottom did yoy total clean the low speed circuit by removoving the plugs on top....see leroys on MQ's...
  18. C

    No power not tilt and trim no chirp when i turn the key

    very....hopefull you had the meter on a lowest scale
  19. C

    No power not tilt and trim no chirp when i turn the key

    true for one fuse but.... if the fuse tested good initially everything should have worked no ??? if a second fuse blew then the load is excessive somewhere... better find out where before you ar 10 miles out ! carry spares !
  20. C

    Swelling Powerpack

    internal short... internal heat excessive current flow may be caused by an external issue
Top