Search results

  1. Scott Danforth

    Mercury MCM165 6CYL 250CID Exhaust Riser for Holley Sniper

    I did the EFI thing back in the mid 80's and early 90s. Spent lots of money to understand that plenum volume and intake design has more impact than whether the fuel is atomized by a carb or EFI until you start varying valve timing. Test peak power and economy before and after.
  2. Scott Danforth

    Mercury MCM165 6CYL 250CID Exhaust Riser for Holley Sniper

    This
  3. Scott Danforth

    Quit My Job . . .

    Ted, just an FYI, your boats upholstery would be about $25k (including the cabin) not including cabinets
  4. Scott Danforth

    HELP!! 2001 Volvo Penta SX running hot

    Check the fitting at the drive?
  5. Scott Danforth

    Quit My Job . . .

    This. if you set up a mobile shop (truck) , you can work when you want, where you want.
  6. Scott Danforth

    Sharp Door Stop

    a piece of large heat shrink
  7. Scott Danforth

    Through hull fitting extension for livewell plumbing

    per your picture, you have to access the non-accessable space. just cut a hole in the deck, glass in a pocket down to the hull.
  8. Scott Danforth

    Engine dies after 40 minutes

    if you think its the tach, disconnect the grey wire at the coil Have you removed the spark arrestor and looked down the carb throat to make sure you get two streams of fuel if you move the throttle? have you tried to open the fuel tank filler cap? if it makes a hissing noise, your fuel vent...
  9. Scott Danforth

    2016 182SC dark blue gelcoat

    have you contacted stingray for the gel coat match? Have you tried spectrum?
  10. Scott Danforth

    aquasport 175 osprey

    LOL.....
  11. Scott Danforth

    Is my mercury oil injected?

    do a compression test. I bet cylinder #3 is low. running on straight gas will take out the motor. first to go is cylinder #3
  12. Scott Danforth

    Sharp Door Stop

    grab a file and round the corners. its a 2 minute job
  13. Scott Danforth

    Boat will not plain fast

    those are anodes to keep corrosion at bay. My guess, with everyone sitting in back, you were too butt heavy for the boat to get out of the hole
  14. Scott Danforth

    Boat will not plain fast

    ^^^^ what they asked. sounds like you had a "boat load of people" in the stern
  15. Scott Danforth

    Can the base of engine work? Two to bolts under engine are rusted and can

    Do a leak down test on cyl 3
  16. Scott Danforth

    aquasport 175 osprey

    You know you have to pull the carb and open it up
  17. Scott Danforth

    Wiring Gauge Question

    downriggers lights amp bilge pump
  18. Scott Danforth

    Through hull fitting extension for livewell plumbing

    Look in a marine catalog Mcmaster is an industrial supply house NPS or barb to barb with a hose
  19. Scott Danforth

    Through hull fitting extension for livewell plumbing

    No
  20. Scott Danforth

    Slip WANTED for Catalina 38’

    start calling marinas around palm beach on the sun coast, you are looking in the $15/foot/month range and a 2 year waiting list
Top