Search results

  1. Scott Danforth

    Engine Serial Number Decoded

    you didnt get all the paperwork then. in addition to the bill of sale, you need the signed title and/or signed registration the DMV/DNR/AHJ whatever you have that registers boats in your area will only need the BOS and signed title and/or registration. you may have an issue trying to...
  2. Scott Danforth

    Swapping out 3.0 for 4.3 mercruiser.

    remember, a jet boat motor is hard mounted to the pump housing. different animal for mounting. cant compare at all.
  3. Scott Danforth

    My serpentine belt tensioner doesn't seem to work right

    you are turning the bolt the wrong way you turned counterclockwise vs clockwise, all you did was remove the bolt holding the idler on the spring loaded arm. do not run like that, it will walk that idler off its post and fling it at your head. now put the bolt back in and turn clockwise, and...
  4. Scott Danforth

    5.7L 350 - 2003 - MAP/ MPI Horizon - Water Distribution Housing ISSUE

    put a 60 watt incandescent trouble light in the bilge, it will keep the temp in the bilge above freezing. then remove that whole air-pump contraption BS that mercruiser puts on their overly complex motor plumbing. you will find that the hoses going to the lower block drains are probably...
  5. Scott Danforth

    No spark plug spark... 170 MC , 1985 Sea Ray

    yep, that is it. follow the wire from the R terminal (R is for relay, sometimes its call I for ignition) that is your feed to the coil + for cranking. now, start at the coil + on the motor, follow that wire to your starter and fix what is broken/not tight/corroded
  6. Scott Danforth

    Swapping out 3.0 for 4.3 mercruiser.

    Why would you want to? First, it would be a nightmare to align Second, it wouldnt handle the torque
  7. Scott Danforth

    Engine Serial Number Decoded

    You did get all required paperwork with the boat when you bought it, correct? Bill of sale, signed registration card and/or signed title. Your boat is a 1986 OMC with cobra outdrive, the motor is a 1986 4.3 V6 rated at 175hp as stated above The motor serial number from OMC is riveted on the...
  8. Scott Danforth

    old 200 Mercury

    your stand is straight up, your transom is angled.
  9. Scott Danforth

    The Equipment Wish List - Recommendations??

    I am still getting decent enough resolution above 8mph. I believe the spec is 12 knots which is 14mph I will look again next time Im out.
  10. Scott Danforth

    Which Motor To Use

    if you want fuel economy, get a much newer motor..... like a newer 4-stroke. other than the ignition your 135hp and 140hp motors are essentially the same. both thirsty in-line 6-banger outboards
  11. Scott Danforth

    1996 Volvo Penta 7.4 will not stay running

    A test port fitting and a mechanical fuel pressure gauge. If you are reading 7-8 psi, it will open the needle and seat and flood your carb However after cranking, if your fuel pressure drops, its either electrical or you may have a restriction in the line or your new pump may not be good
  12. Scott Danforth

    The Equipment Wish List - Recommendations??

    FWIW, a 7" Garmin with down view / side scan can be had in the $600 range I know its readable at well over 50mph, and the side scan is good to about 20mph if you wait a month, the unit you were looking at will be reduced again as new units come out.
  13. Scott Danforth

    The Equipment Wish List - Recommendations??

    BTW, if you want better than 2 meter accuracy, you have to be military
  14. Scott Danforth

    Lifting the Engine 5.7L - Weight

    with exhaust and heat exchanger and fluids, expect about 800# stock lift points are best, loop on front of thermostat housing, one loop on back of each cylinder head. however without the front loop, find one of the other bolts in the front of the head. or pull the exhaust manifolds off and...
  15. Scott Danforth

    2006 Merc 8.1

    have you looked at manual 33?
  16. Scott Danforth

    Adding Transom walkthrough to wake boat

    please explain this shop that would only charge "couple hundred dollars" i have a whole bunch of fiberglass work to send their way then. Just the upholstry work alone will be over a grand, the fiberglass work will probably be in the 2-3 grand range.
  17. Scott Danforth

    1996 Volvo Penta 7.4 will not stay running

    go back to basics what is your compression? what is your fuel pressure? running for a minute and stopping is lack of fuel. i would look at the fuel pressure to confirm. Volvo's get their non-cranking fuel pump voltage from the alternator.
  18. Scott Danforth

    The Equipment Wish List - Recommendations??

    what is your budget, also remember, there are a bunch of sales that are coming in a week
Top