Search results

  1. Scott Danforth

    Small Cruiser Stereo Upgrade

    you can, however you will have clashing music because its not a big boat which would get annoying. see for your self, use a bluetooth speaker and place it in the cabin, then see how each "zone" has to listen to two different songs on my boat, I have the cabin speakers running direct off the...
  2. Scott Danforth

    Max Horsepower Rating Interpretation

    because the load path is different on an I/O vs an outboard an outboard is clamped to the top of the transom, the force of the prop is trying to pry the transom off the back of the boat with a long lever arm an I/O is mounted low to the transom and stringers, much less force on the transom...
  3. Scott Danforth

    Four Winns cover pooling and leaking new owners

    boat covers should be re-sprayed every 6-12 months with water proofing the pooling may require a second or even a third pole
  4. Scott Danforth

    Looking for best 2 cycle motor

    sounds like you have the same luck I do.....
  5. Scott Danforth

    Is the bilge drain hole to small or am I stupid

    turn the connector to re-aim the wire
  6. Scott Danforth

    What´s the best replacement for AQ271C (or 570) 5.7 GM engine, ideally stroker?

    the mercruiser camshaft is same for the 350 and 383, only difference is the 1.6:1 rockers. they use a flat top 4-relief piston (not a proper piston for building a 377 or 383)
  7. Scott Danforth

    1988 Rogue 2420

    cant get the new carb to idle or respond to the 4-corner idle mixture screws, yanking it off again to verify the transfer slots on the secondaries
  8. Scott Danforth

    Mercrusier 3.0 and 4.3 compatiblity

    you can get props low enough if the drive is a 1.81:1. however if its a 1.62:1, no also, the inline motor has a different input shaft than the V-motors. you will need to swap input shaft
  9. Scott Danforth

    OMC to Volvo Penta?

    reason I ask, the Y-pipe isnt there. that part may cost you as much as $500 to find. and transom shields from behind the 4-bangers do not have the extra idle relief holes.
  10. Scott Danforth

    Low Voltage - Engine Voltage is low

    first, stop playing with the font second, welcome aboard 3rd, you are reading low voltage, either from a bad connection at the batteries somewhere or bad batteries. anything below 12 volts is considered a dead battery. start by load testing your batteries and cleaning your connections until...
  11. Scott Danforth

    No spark 4.3 Mercruiser

    fuel pump is only on while cranking is normal. the other wire wont power the fuel pump until there is oil pressure.
  12. Scott Danforth

    No spark plug spark... 170 MC , 1985 Sea Ray

    bullcrap. you dont even need the distributor cap on to check dwell, you need the dwell meter across the coil terminals and you need to be able to crank the motor. thats how I have been adjusting point gap for nearly 40 years. timing light while cranking is how I normally set timing on any new...
  13. Scott Danforth

    Vintage Trolling Motor " Twin Fins" manual trolling motor circa 1950's

    as far as value, maybe as wall art. using it would get old after 50 feet and it would scare the fish away.
  14. Scott Danforth

    No spark plug spark... 170 MC , 1985 Sea Ray

    if there was any current, you would be dead when it shocks you points film over when sitting however you have stated repeatedly that you have spark at the coil. if you have spark at the coil and none at the plugs, its either the cap, rotor, or wires if you do not have spark at the coil, the...
  15. Scott Danforth

    Outdrive trim pump, where is the power source

    follow the red and black heavy gauge wires from the trim pump relays (not the green and blue from the switch). where it attaches to the starter. there will either be a fuse or a circuit breaker. yes, look at the connection on the back of the starter
  16. Scott Danforth

    MerCruiser 120 1968 2.5 not idling tight

    first, start with the basics. is the motor healthy? what are the compression numbers? a good motor should be 140psi or so, a tired motor will be about 110psi per cylinder second, what is your fuel pressure (you will need the test adapter) it should be between 4 and 6 psi third, what is the...
  17. Scott Danforth

    1972 Hi-Laker 14 foot Fiberglass Boat

    first, welcome aboard. second, I believe its only rated for 35hp
Top