Search results

Good day, I have pulled outdrive and have found a small amount of water in the bellows. There's no rust on u joints and so on. Any suggestions or is it normal

Ok thanks

Quick and easy question...if I fog my engine for winter will it gum up my carb...boat is running sweet and I don't want issues in spring

Right o..thanks

I'm not sure if I'm in the proper section for this but here goes. My boat is a 23 foot with a cabin in front with storage under cushions. In rough water it's loud as heck when I'm hitting waves. If I were to use spray foam in the storage areas..would that stop noise and perhaps help buoyancy.

There's a v shape you can see in the pictures...the second pic below the bolt

It will be under all the rust somewere

I went 4 percent richer so we will see how it goes...I can go another step up on rods if needed but jets and springs are maxed

Ok

Ok so if I go wot and here the ping and I back out just a touch it's gone. No harm being done to engine?

Sorry had my microns mixed up...I have 100 between tank and water separator...and 10 between pump and carb

What's your take on the plug condition

I have a feeling we have had this same conversation. Or perhaps with someone else

Yes I did...it's all been broke in properly and according to the builder.

There autolite 124. And no idea about heat chart

Not exactly sure but low...couple hundred probably

Ok so shall I try cooler plugs?. Bigger jets again?

Out of curiosity what micron fuel filter should I use. Reason I ask is I've been chasing this lean wot slight ping. I installed a 100 micron I believe it was. Perhaps not enough gas getting through?

How does this look. This is after I fattened up my jets, metering rods and springs

Right o...I'll bleed air out I appreciate the help