Search results

Want to install these new boat buckles on my trailer. Not sure if either location causes an issue. Need inputs please. Thank you

Ok thanks

Might be a stupid question but does the fuel water separator do a good job at filtering out particles from the boats built in fuel tank?

Pretty sure that's just the built up sealant cracking

Getting ready to install a new to me yamaha 130 hp 2 stroke on my wellcraft 190ccf center console. Lower bolt holes have these thick square metal plates on the inside (ignore the thin plate with 2 screws used to hold the bolt head when tightening. Think it's OK to leave the square plates as they...

Do I need to just cut off the existing end and then heat it up and put a glob of solder on it?

I have a new to me boat which came with a Shakespeare vhf antenna but no radio. I'm installing a uniden um385 have 2 questions. Does the end of this cable look normal? Should I be receiving communication at my house? I'm about 40 min from Salt water and 20 min from the Delaware river...

Replacing prop seals and bearing carrier o ring. Got the carrier out but wanted advice on using antiseize on the big carrier retaining nut threads. Good or bad idea? Also need the torque spec for that big retaining ring nut. Thanks 2001 yamaha 130 hp v4 2 stroke

Just checking which is preferred bundling the excess harness lengths at the helm under the center console or at the stern before it passes through to the outboard? Some of my harnesses have a lot of extra length. For what it's worth it's a 1997 wellcraft 190ccf with 2001 yamaha 130hp v4 2...

Rigging a 2001 130 v4 2 stroke. Looks like yamaha wants a fuel hose from the primer all the way up to the filter with no quick disconnect coupler. Was thinking about adding one but all the Rigging coming out of the motor well is going to be inside a Rigging tube with the exception of the fuel...

I still had a concern because the rule of thumb was 1 inch up for every 12 inches of setback but I only have about 7 inches of setback. And I was hoping to get info from owners of the same boat. Sorry

my 1997 190 ccf is about to get a 2001 yamaha 130 2 stroke installed. There is no room in the transom area for the oil tank. I think I have to put it on the floor of my center console. I will run a remote oil filler plate to the side of the console around where the 190 ccf decal is. Seem like a...

getting ready to install a 2001 yamaha 130 v4 2 stroke on my 190 ccf. original engine (johnson 115) was installed so that cavitation plate was about 1 inch from the bottom of the boat (boat uses a stepped transom with about 7 inches setback). Do you guys advise just mounting the yamaha so that...

I just found them. Bought just the bezel for key and the single kill switch part. Thanks

I like that. Where did you find those? Have any part numbers?

Good idea. 👍

I have to mount my key switch panel sideways for my 2001 130 v4 2 stroke due to space issues. This puts the key switch in a position that makes it look like it's on even when off. I tried rotating the switch 180 degrees but same thing. Due to the flats on the switch body and panel. Any way to...

Getting ready to take the johnson 115 off my 97 wellcraft 190ccf center console. Lower bolts have some kind of tab over the head of the bolts. What is the purpose of these?

Because I haven't beaten this to death I measured my actual setback at 7 inches so I guess I should be 1 inch up from the bottom of the boat?

I'm thinking it's a good idea to change the under cowling fuel hoses. Instead of buying all the individual hoses do you know what size that fuel hose is? Might buy it in bulk instead. My gas hoses feel pretty hard to the touch is the reason I'm thinking of replacing them. Thanks