Search results

So it looks like I'm going to have to put my remote oil tank for my Yamaha 130 v4 in my center console and run a filling hose from a deck fill cap cut into the side of the console. Boat is a 1997 wellcraft 190ccf I know the remote tank harness is long enough but what to use for the hose from...

I don't know. There are several wires there. I assumed green but I could be wrong. Also is a trim sender standard Equipment on the 2001 yamaha 130 v4? I have a 1999 version in my garage and I don't see any trim sender wires coming out of the hole in the bracket where the main power trim motor...

Ok I think I get it now. The green wire from key switch panel goes to the tach for tach signal after being carried via 10 pin harness to the switch . Sounds better to me now if that's correct .

I don't see orange wire on engine side wiring.

Thank you that is very helpful. So I need a trim oil harness with 2 plugs on both ends and the interface harness to use the digital tach. How does. Rpm get handled. It's not in either of the 2 trim oil harness?

This is the analog tachometer with power trim guage and the digital also with power trim guage on right side

2001 yamaha 130 v4 2 stroke. Want to install either the analog tachometer with oil and temp warning and trim position indicator all in 1 or the digital version of the multi tach. Using a 704 binnacle remote with a separate key switch. Also using a remote 11 quart oil tank. Under the hood next to...

Nevermind I see other motors have the same thing with that nipple capped off. Not sure what thats all about but feel better knowing this was yamahas doing not the previous owner

1999 yamaha 130 v4 oil injected. What is this capped off pipe on the bottom of the engine oil tank? I see one oil hose that comes from the remote tank and 1 hose out the bottom of the engines tank going to oil pump. Not sure what the other capped nipple is for on the bottom of this tank?

Anyone know if a oem carb kit comes with enough parts to do 2 carbs or do I need to order 2 kits? Looks like kit is around $150 each!

Ok 👍

Ok yes good point. What thickness do you recommend?

1998 wellcraft 190 ccf center console. NEED to remove omc wide controller and install a 704 remote. Hole for 704 remote is much narrower than the omc hole. Here's some pictures. Thinking of a way to cover the too wide hole in the console. Would a sheet of abs plastic work to screw to the console...

Anyone have success using a aftermarket power trim relay? Big price difference between oem and aftermarket If so what brand did you use? My motor is a 2001 yamaha 130 hp v4 2 stroke

Ok I guess it's just a bonus that yamaha gives you then. Thanks

Ok I had a 1985 115 with a remote tank but pretty sure it didn't have a squeeze ball?

Ok is it only used for that? Does it stay in line once the system is up and running?

Looking to buy a new remote oil tank for a new to me 2001 130 hp v4 yamaha. Anyone know what the primer squeeze ball is for? Is it in case the pump dies in the remote tank? Thanks

Ok I got it now. Thanks for your patience