Search results

So that would be at the 2 wire connector?

Working on trim guage again. I disconnected the triangle connector and put a jumper from the white with brown stripe pin to the sender on the guage. I also put power and ground to the guage. The guage is not changing when tilting motor up and down. I also jumped the white with brown stripe wire...

Can you tell me where to attach the pressure guage on the powerhead?

Ok I guess I'll check back at the motor to see what's going on. Thanks

Anybody have an answer as to if the white with brown stripe wire in this harness connector is for trim guage signal?

I looked all under the dash. Not finding the 3 loose wires with ring terminals. I found a white with brown wire in a connector with no wire coming out the other side of the connector in line with the white with brown wire. I put power and ground to the guage and jumpered a wire from that white...

Probably not I found a round connector under the hood with wires from the sender. I think 1 black and one white with brown . How do I test at that connector?

New to me 1997 johnson 115 spl v4 bubbleback. Disconnected triangle connector under the connector panel after removing the cover of the connector panel (under the hood). Ignition key off I put a clamp on the green pin and one on the blue pin. Full down shows 158 Ohms. Meter goes to 1 while...

What do you recommend to decarb? Dump something in the fuel? What oil should I use? I have a gallon of quicksilver 2 stroke oil from a different project.

Thanks. I scored big time. Hopefully it performs as well as she looks

Ok thank you

Just bought a 1997 wellcraft 190 center console it came with a 97 johnson 115 spl motor. Looking to get a shop manual. I bought this manual on ebay but don't see my model number listed in the manual. My model number is XJ115HLEUA PIC OF MY MOTOR and the manual I bought. Will this manual be good...

Lawrenceville nj

Picture of head gasket

I acquired a 2003 90 hp 3 cylinder with oil injection. Top 2 cylinders 120 psi bottom 50 psi. Bottom carb overflows when running engine I assume because not enough compression to pull in the mixture or the float is stuck. Not sure what the condition was when the bottom cylinder went bad...

Thank you for the info.

Looking at a 1990 hydra-sports 18 ft center console boat. Anyone know if these have wood construction in floors or transom? Any known issues, decent boat?

Looking at a 2007 trophy 1703 center console boat. It has a mercury 125 2stroke in good shape. I have a yamaha 90hp 2 stroke year 2003 in excellent shape. I'm thinking of buying the boat and swapping over to the yamaha. I grew up with yamaha and prefer them over mercury. Anyone think this is a...

Awesome. Yes I'll check those 1st. Do you know how many poles I need to select. Aftermarket tach. 2000 40 hp 3 cylinder