Search results

Here are some pictures of y pipe. I ran water down both pipes and water was going into bilge.

My suspicion is the top portion of y pipe isn't sealed correctly as the water leak is coming from the top

Alright...I pulled outdrive and there is water in the exhaust bellows..none in drive bellows...o ring still inplace

I haven't ran it on muffs yet.still waiting for dizzy. It's leaking below the drive shaft and above y pipe. I haven't pulled drive yet but I guess I will

I replaced the bellows and also redid the y pipe. I put boat in water and there is a steady stream coming from just above the top y pipe bolt. Any suggestions

There was no pin and the flywheel wasn't drilled to fit so it must be good.thanks guys

What's concerning me is the weights location relevant to crank type thing

Here's how it was put in....flywheel onto studs with the indent portion facing out. Coupler onto studs. There was no key way or line up marks

I have since installing new engine if the flywheel was installed the same way it came off. I haven't started it yet as no distributor. I was told by my help that it really doesn't matter. It went on easy so my question now is...does it matter...and if so now what or how to tell without ripping...

I'm in the middle of installing the manifolds right now . So if there on good to go ???

The new engine is in and mounted.

I will add that my outdrive is in and all sealed as in bellows and gaskets

My engine isn't ready to use. I have not hooked up my exhaust manifolds or elbows. Y pipe has new flappers. Is it possible to use boat with the kicker or will my boat sink

Here is pic...it's the top outlet I cannot blow air through

Winterized kicker and had good tell tale. Just installed it back on boat and no tell tale...I can blow through the hoses except the top hose port. Also curious if I should get the wash fitting on the side. Will that push more water then using muffs. Not sure how it does not pump now

Thank you for the help....outdrive slid right in.

Perfect thanks...I.got it in all the way by tapping the tool around a bit

Problem is the bar doesn't go in far enough to make marks in the grease

Not sure how to find that

I have tried spinning it as well...tomorrow is a new day...may just slide in. I've never had this much trouble