Search results

Flat tappet is 1985-1987 However NOT metric

Since there are no standards for fuel fill. You have to find the exact one. Or just buy a different one

e10 does a better job of cleaning combustion chambers than oil does.

I wouldnt. the oil in the 2-stroke does not play nice with your catalytic converter.

yes. you have to pull the drive, then pull the motor a little over an hour

first try a shop vac with a soft bristle end. if that doesnt work, some 409 and water rinse will work (assuming the cabinet drains) the "gunk" could be dialectric grease or some other electrical sealant that is now brown

remember, there are 4 generational changes for the 4.3 from when the vortec heads came out (8 bolt intake) so, identify what you have and what you need by the block casting number 1996-2000 2001-2007 2008-2015 2016-today

if you remove the motor, yes, you can tighten the y-pipe. however they dont just loosen up by themselves. check the transom.

welcome aboard. sounds like you have two issues. the squealing and the steering pulling to the left. check your alternator bearings and power steering pump as well as the belt. regarding the pulling to the left. does the boat list a bit? if it does, could be weight issue, or wet foam issue

There should be an aluminum plate bedded in the fiberglass for the screws to thread into

https://www.mcmaster.com/epdm-rubber/thickness~3-32/width~6/length~6/

EPDM gasket sheet. Not same as roofing membrane

undo steering cable from transom assembly. tie a section of rope onto the end of the cable. undo the steering cable from the helm. pull cable up to helm. you may need a helper connect new cable to rope, pull and push back the other way

EPDM

Volvo Penta has been using power steering for over 45 years and has had 7 different systems

Cables generally wear thru the inner sheath. Just spend the $30-40 and get new

Grainger has best prices on Carling Circuit breakers. They are under $3

or the boot fell off (which is also the retaining nut) and they simply replaced the nut with what they had.

the CB cover is just missing. https://www.amazon.com/AlveyTech-Waterproof-Push-Button-Circuit-Breakers/dp/B07V6LKF84 https://www.ebay.com/itm/284248062284

automotive engines need to run at higher temperatures for emissions reasons as well as other reasons. boat motors need to run as cool as possible to keep the minerals in the water from falling out of suspension while being just warm enough to minimize wear. unless you add a heat exchanger to...