Search results

You put grease on the cradle.----Slide propshaft in.----Drop shifter fork into cradle.----Done in just minutes.

Detent ball hold it in NEUTRAL only !

Post pictures of forward gear dogs.-----And edges of cleaned clutch dog, forward and reverse.

Tell tales are for " dummies "------Install a new impeller every 5 years !!-----Test your overheat light.----Better yet install an overheat warning horn and test it every year..

Sorry----No peektures from me.----Come over I show you where to take one out to take home.

Pinion and forward usually come as a matched set.-----Note-----This work is not the same as installing new sparkplugs in a motor !!

Grease fittings are in plain view on the port side of the swivel bracket.----Found them on several midsections.

Agreed.-----At one time I corrected some sellers with motors listed as 10 or more years newer then they were.-------Amazing replies and I do not do it anymore.

Use a timing light to check the timing as it is now.----From 1964 on these can run at 50:1 mix.

Will look at some tomorrow.

That wire goes from carburetor area to under the flywheel.-----Part of timing advance for starting and warmup.----Check oil in lower unit.---Check shift adjustment.

Evinrude stopped production of E-TEC and E-TEC G2 engines in June 2020 !!----There may be some still available at some dealers.

Powerhead removal is suggested here.

If there is any water in a gearcase it is time for a seal kit !!

From here with that 26" measurement I say the motor is an EXTRA LONG model.

Problem is not the head gasket.----Now you know that fact.----So issue is internal blockage or grommet / water tube issues.

Well some mounting brackets ( on motors ) are drilled to let you set a 25 " motor at the " perfect " height on a 22" transom.

It is NOT pumping air !

I would say that 20" is LONGSHAFT.--------25" is an EXTRA LONGSHAFT.-----The boat shown will likely work with a 20" motor.-------But it looks like there is some work to be done before you can hang a motor on that transom.

I think you need to do a complete , very complete evaluation of this motor BEFORE spending any money for parts.----Where is it ( location ) that this is the best deal you can find ?