FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Pulling the flywheel on a 1978 35hp. Have the puller not sure what size the 3 bolts i should use are? someone suggested 1/4x20 should these work not sure? thanks alot
There has been some confusion on this site (and apparently in Evinrude owner's Manuals too) about the size bolts. They should be 1/4-20 on this size and vintage engine. There is a possibility they may be 5/16-24. Whichever size bolts you use be careful to avoid running them in too deep into the flywheel. If you run them in too deep they can contact the coils and make quite a mess.
