In Need Of Powerhead 1965 18hp

[outboardguy33462]

During taking the starter off the motor where the ground is the piece snapped off tried jb kwik and it did not work wanting to know where i can get a powerhead

 

[tashasdaddy]

Re: In Need Of Powerhead 1965 18hp

SALVAGE YARDS

Try some of these:
sea-way.com
outboard-parts.com
laingsoutboards.com
tcoutboard.com
fairwindsmarina.com
salvagemarine.com
marinepartsoutlet.com
outboardexchange.com
Superior Marine (800-338-9281)
budgetboats.net
americanoutboard.com
piratemarinesalvage.com
trixieslanding.com
mmmarinesalvage.com
tcoutboards.com
Tim's outboard 218-682-2331

 

[14ftgrumman]

Re: In Need Of Powerhead 1965 18hp

PM me.
I bought a powerhead that had been dropped and all the bosses for the starter and recoil mount were broken. Had them welded and redrilled and tapped the mounts. If the broken one is th one I think it is, it can be built up by a good welder and then redrilled.

PM me

 

[jack sprat]

Re: In Need Of Powerhead 1965 18hp

call this guy i was going to get this powerhead but i found a complete motor.
Brian at Parts Wharehouse www.obparts.com he wanted 95.00 for a complete running head hopefully he still has it his #270-618-5200. I hope that helps! Good luck.

 

[outboardguy33462]

Ok again 1965 evinrude 18hp fast win

Ok again 1965 evinrude 18hp fast win

ok i posted a couple of months ago about a powerhead i got the piece welded and the motor is back together running but the plug wires are all messed up any one know of a schematic or some info about this process

 

[bktheking]

Re: Ok again 1965 evinrude 18hp fast win

Re: Ok again 1965 evinrude 18hp fast win

Plug wires need replacing?

Pull the flywheel, pull the mag plate, 4 phillips screws hold it down. Pull the wires and replace with new, the ends screw into the coils, the other end pull the boots off and the spring locks. Put the tip through the new wire (spring locks) , put some dielectric grease in the boots and shove the new wires throught.