Reinforcing bilge vent anchors and recommendation for 3" vent hose

ejnichol

Petty Officer 1st Class
Thread starter
Joined
May 28, 2002
Messages
206
One thing leads to another. Replacing dried and crush bilge vent hose required removing these 'fashion' vent fittings.

What kind of adhesive would you use to resecure these bolt bases? There glued on with some 2006 era marine construction adhesive that is failing but have only lost one.

Would you use t headed bolt to replace the missing end one. Secure with same adhesive as above?

Also what is a good quality 3" bilge vent hose?

Thanks.
 

Attachments

  • 20261119_122337.jpg
    20261119_122337.jpg
    603.7 KB · Views: 10
  • 20261119_122458.jpg
    20261119_122458.jpg
    495.6 KB · Views: 10
  • 20261119_122502.jpg
    20261119_122502.jpg
    800.3 KB · Views: 10

ejnichol

Petty Officer 1st Class
Thread starter
Joined
May 28, 2002
Messages
206
I would scuff both pieces well and use a 2 part epoxy.
I'm thinking epoxy would get brittle quicker. My experience with two part epoxy leads me to believe they might fail after a few years.

3M Marine Adhesive Sealant 5200 might be an option.
Those vent are no longer available so don't want to lose them.
 

Scott Danforth

Grumpy Vintage Moderator still playing with boats
Staff member
Joined
Jul 23, 2011
Messages
53,435
was probably plexus. that glue joint lasted longer than it was designed to.
 

ejnichol

Petty Officer 1st Class
Thread starter
Joined
May 28, 2002
Messages
206
was probably plexus. that glue joint lasted longer than it was designed to.
Several owners of this era boat with this vent design reported having 'lost them' .

It would help if I knew what this vent was made of. The missing one I could probably replace with a toilet flange bolt I have on hand. Just need to determine what adhesive to use.
Edit to add I believe its Abs as acetone affects it.
 
Last edited:

redneck joe

Supreme Mariner
Joined
Mar 18, 2009
Messages
16,766
find some teak or mahogany and make new if you are into wood. angle grinder with a box of flap disks.
 

ejnichol

Petty Officer 1st Class
Thread starter
Joined
May 28, 2002
Messages
206
find some teak or mahogany and make new if you are into wood. angle grinder with a box of flap disks.
Are you serious? LOL This winterization project has grown exponentially. Only because I'm retired and the weather been favorable for outside work that's its all getting done.
 

ejnichol

Petty Officer 1st Class
Thread starter
Joined
May 28, 2002
Messages
206
I would take what you have, use it as a plug and make a mold to make fiberglass versions
That would be better for strength but I don't have the time to invest.

I think I've found an adhesive in Plexus MA302. Trying to locate a retail packaged version here locally.

Will test it out on one anchor. Read where is not compatible with brass flange bolt so will need to get a stainless elevator bolt etc..
 
Top