Search results

  1. jerryjerry05

    1990 force 50hp spark issue

    The coils are basically the same except the connectors are backwards. They did that so you can't mix the blue and black together. Just swap the whole ignition system if there's good spark on the donor motor. outboardignitiondotcom has a troubleshooting section. One quick check: the trigger leads...
  2. jerryjerry05

    1972 Chrysler 707HE 70hp 3-cyl conversion to automotive coil how to?

  3. jerryjerry05

    Top piston worth replacing? (120hp low compression)

    For the intake to block seal: I use the black RTV/Silicone
  4. jerryjerry05

    70hp Force shift adjustment

    What shift system? Pics of the cable ends?
  5. jerryjerry05

    1988 85 horsepower force motor carburetor parts

    ebay might have something?? They sell white plastic floats as a direct replacement: they don't usually work. Outboard salvage yards Marine salvage etc.
  6. jerryjerry05

    Anyone here swapped a Mercury for their Force motor using the Force transom bracket?

    I don't think anything will match up?? The 76 150, it's gonna use a LOT of gas.
  7. jerryjerry05

    OMC Cobra tools / dimensions

    ebay
  8. jerryjerry05

    1989 bayliner 85hp Force Starting Issues

    Is the choke stuck on? If he manually activated choke, then change the plugs and use a bit of starting fluid. Could be he flooded the engine???
  9. jerryjerry05

    1989 85hp force outboard no start issues

    Loosen the choke body and move it up or down then try the choke??
  10. jerryjerry05

    120hp Force stuck in Neutral

    Need to post a few pics of the shift linkage and lower unit. They made 2 different drives a 3 and 6 jaw lower. Need a pic of the bolt that holds the trim fin in place. Then I can tell what drive you have? 3 or 6 jaw
  11. jerryjerry05

    Force 85 Control Operation

    If it's stiff then the cables might need changing/adjusting??
  12. jerryjerry05

    Installing cdi on force 90

    Post is 8 years old, Ohio 79 hasn't been on for a while? Read the rules?
  13. jerryjerry05

    1989 85hp force outboard no start issues

    Choke working right? or does it have a primer? The butterflies need to close all the way.
  14. jerryjerry05

    Carb leaking gas from top two holes 1989 85hp

    Pics of the motor and the transom and the bottom of the boat and the cavitation plate. You might need trim tabs or the hydrofoil? Start another thread.
  15. jerryjerry05

    Force 85 Control Operation

    The 88 model has a throttle that in N you can pull the handle out and that disengages the shifter. Then you can throttle a little for starting once you pull the handle. The choke is activated by pushing and holding the key in(it should activate the choke slide and butterflies) that causes...
  16. jerryjerry05

    89 force 125 trim issues

    The first 4 posts in the Force forum. Read them, they cover a lot on the T@T It sounds like your pump needs the shuttle valve seals replaced??? See pics, #3 shows the bad seal and the new one.. The pump itself: there's nothing in the pump that you can fix s try not to "fix" it.
  17. jerryjerry05

    Carb leaking gas from top two holes 1989 85hp

    Found the elephant: last year one of my customers asks me to get a 97 120 started after it fell off the pontoon. He neglected to tell me if fell off in salt water and set for over a year and nobody did anything to protect it :( The carbs, were in really bbaddd shape, right into the dumpster...
  18. jerryjerry05

    89 force 125 leaking fuel from carbs

    The foam floats: usually they don't get saturated? make sure there set right? the brass plugs with the hole are for low speed jets(not used on all the 89 125 carbs)(wonder if they were replaced somewhere along the way???) there was 3-5 different carbs used on the 125. Post a few pics of the...
  19. jerryjerry05

    ‘86 125 Force 2 cycle ran without oil

    If they were gonna walk away they wouldn't be on here asking questions. Sounds like there's some oil mixed in it already. Do the tests and drain the tank and don't forget the fuel in the carbs and fuel lines.
  20. jerryjerry05

    Carb leaking gas from top two holes 1989 85hp

    You only need 1 post, I thought somebody deleted the other? Read my response in the other post.
Top