Search results

  1. alldodge

    5.7 EFI stalls when warm and shifting into gear

    You can either get a Merc adapter (91-806901) or can remove item 3 (plug) and attach gauge there https://www.mercruiserparts.com/bam/subassembly/31880/2338/130
  2. alldodge

    sterndrive to gimball

    I would think a new gasket
  3. alldodge

    Anyone please help with my mercruiser 5.7 thunderbolt v igntion engine, hard to start

    With it be hit or miss it;s most likely electrical. Which means your back with the distributor or shift interrupter
  4. alldodge

    Maybe my turn for new boat time

    Don't know who installed OB's my guess was dealer. I plan to call Chap next week to find out. Looking more and more the Lake Cumberland Marine is a never was kind of place
  5. alldodge

    Mercruiser 4.3L lift points

    Yes, so long as they are opposite sides and ends Exp: left front right rear
  6. alldodge

    4.3 cranks idles but dies.

    Unplug switch and put jumper across the terminals. When key is turned ON pump will start to run. If this fixes the issue then its the switch. Don't leave jumper there it's for testing only and not safe to leave i that way
  7. alldodge

    Mercruiser 4.3L lift points

    Yes 4 ft should work but I would suggest 6 ft long
  8. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    one of these. Techmate is lowest cost but is not able to record and play back later. Diacom software that goes on your laptop can play back https://www.rinda.com/marine/marinemenu.htm
  9. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    Need to get the motor scanned for codes Rinda makes the scanner to be able to scan motor Without a scanner we will be just guessing. Could be a bad connection even something simple like the ignition switch or other bad connection
  10. alldodge

    Mercruiser 4.3L lift points

    If your talking about lift points, sometimes they are removed after install Can use a bolt and put it thru the chain and attach to the head. I like using 2 one inch lifting straps and place them under the exhaust manifolds and attach to hook above carb
  11. alldodge

    Maybe my turn for new boat time

    Sent pics to dealer and their response was they forward them to Chap Good grief
  12. alldodge

    4.3 running great accelerated slowly died. No power at key, no click, nothing.

    Check fuses
  13. alldodge

    25 EFI fuel pump not work

    Welcome Don't know much about the motor but the fuel pump is turned on by a relay. The ECM does energize the relay by applying a ground to one side of the relay coil. Check the relay and fuses
  14. alldodge

    Pre-start system check Whistle not heard now Crank / no start

    What's your serial number?
  15. alldodge

    VOLVO PENTA 5.0 GXI Engine suddenly stalled after 10 minutes of running at 3000 rpm

    What are you using to diagnose? Sounds like something is heating up
  16. alldodge

    Black Scorpion Mag Mpi fuel pressure

    Good deal
  17. alldodge

    2005 350 Mag dropping fuel pressure under load

    Bad connection somewhere The relays are Main power and other is fuel pump. Main powers up entire motor and both are same kind and can be swapped.
  18. alldodge

    FWC V8-300-C-A

    What MUC said
  19. alldodge

    FWC V8-300-C-A

    Statement is not clear for this old guy Please clarify?
  20. alldodge

    5.7 Mercruiser flushing options

    With a B3 drive you have a I/O and not a Do run it off muffs and not the flush fitting. If you do have dual water pickup (holes at nose of drive) tape or seal them up when using muffs
Top