Search results

  1. alldodge

    2005 Chris Craft with 2 impellers overheating

    Does the more raw water pump run from a belt of off the crankshaft? Hey @Fun Times can you look up this serial number 0W312448 Looking to see if it came with additional raw water pump
  2. alldodge

    2005 Chris Craft with 2 impellers overheating

    Something jut doesn't sound right about that. Has a Alpha drive and Bravo or crank mounted water pump? Which other pump does it have? My initial thought is motor was getting hot and original dealer had a motor run pump installed. From my thought I would rather see the impeller removed from...
  3. alldodge

    Gas and fuel mix recommendations for JW-10

    I'm no expert on the old OB motors (hope to see some of those folks chime in) but do know that ethanol is bad for the old I/O's. 91 octane gas won't hurt the motor but you may have slightly less HP. The higher the octane the slower the gas burns
  4. alldodge

    Gas and fuel mix recommendations for JW-10

    This older thread list 24:1 https://forums.iboats.com/threads/fuel-mix-in-old-johnson-3hp.211119/
  5. alldodge

    Help identify this livewell pump

    Don't know but there should be a model on the pump That said, don't need to get same one
  6. alldodge

    Idle issue 4.3 mercruiser LX

    Don't do that, the motor runs so its not the distributor
  7. alldodge

    1996 ski sanger 315hp black scorpoin multi fuel injection.

    Spec for that motor is 43 psi and you should see right around 40 psi at idle If you were getting more then that it could be the Regulator, but less then that could be wrong regulator was installed If it was mine I would pull injectors and have them cleaned and flow tested. Would also send them...
  8. alldodge

    Help Identify This Fuel Sender

    Search "WEMA fuel sender" but you still need to know how long https://www.amazon.com/wema-fuel-sender/s?k=wema+fuel+sender
  9. alldodge

    1972 Checkmate MX-15 Rebuild

    That's purrrrdy Need another trailer, boat that nice should be on a custom just as nice
  10. alldodge

    Idle issue 4.3 mercruiser LX

    Inductive pickup is the way to go, but don't need the advance type
  11. alldodge

    1996 ski sanger 315hp black scorpoin multi fuel injection.

    Moving thread to the Merc section Inboard Should measure 43 psi fuel pressure at the rail. Three pumps in 2 years, do they loose pressure or something else? What lead to replacing the pump?
  12. alldodge

    1972 Checkmate MX-15 Rebuild

    Real nice
  13. alldodge

    Idle issue 4.3 mercruiser LX

    There is a lot of "IF's" going on in the thread and need to no what is and is not happening IF the carb is flooding it needs rebuilt, if not then it probably doesn't Motor lowest RPM is at 2200, cable has been removed from the carb and even when pushing the carb throttle plates closed it still...
  14. alldodge

    Part of my Inner Transom is Rotted.

    Git Rot will not displace water, so with wood being wet it's useless IMO Once transom has gotten soft it needs to be replaced
  15. alldodge

    Idle issue 4.3 mercruiser LX

    That's a weber carb and it will have a number stamped on the side of it. I would contact Mike's carbs and get a kit there. Could order the Merc rebuild using 8M0120196 but Merc just adds cost
  16. alldodge

    Idle issue 4.3 mercruiser LX

    If it's flooding then rebuild time No way to adjust pressure
  17. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    Wait until the beeps stop then start
  18. alldodge

    4.3 Gl over heat

    Hey @Scott Danforth
  19. alldodge

    ECU pinout/wiring diagrams ???

    Same here that's why I stay clear also
  20. alldodge

    Anyone please help with my mercruiser 5.7 thunderbolt v igntion engine, hard to start

    Think your main issue may be spark. The TBV ignition is a good solid system when it works. The most problem cause for the lack of spark is the sensor 892150Q02 in the distributor and that's for the ones which have not had them replaced with new style. New ones have an additional wire which...
Top