Search results

  1. alldodge

    4.3 mercruiser alpha 1

    Agree with Scott If you go with V8 in a 5.7 (5.0 about same as 4.3) would need to move motor mounts
  2. alldodge

    My boat is being a boat . . .

    About 2.2 at about 3200 rpm which is 30 mph
  3. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    Can see the second vid, but first just hangs I'm on 6MB DSL maybe that's it Either way I don't know
  4. alldodge

    Breakfast Dishes and Biscuits

    That does sound good Thanks for the posting I forgot to come back with new biscuit recipe. Called Johnny Biscuits, look it up The mix is mostly wet and then you scoop the wet out and drop in all purpose flower and roll into a ball. Place in cast iron skillet and cook at 425. They Doooooo...
  5. alldodge

    My boat is being a boat . . .

    87 here is 4.90 so not a lot better
  6. alldodge

    4.3 mercruiser alpha 1

    ...
  7. alldodge

    4.3 mercruiser alpha 1

    Probably are, my guess is the block cracked from not being winterized correctly. No way should AF wind up in the pan, something is busted Remove the thermostat housing and then use a garden hose and pour water in it. It will probably come right out the pan
  8. alldodge

    4.3 mercruiser alpha 1

    AF in the oil pan, well that's not good
  9. alldodge

    4.3 mercruiser alpha 1

    There is rust on the bottom of the plugs, and a bit on a couple of the tips. The rigs are probably rusted to the cylinder walls Spray more oil in the cylinders and let it sit for couple days
  10. alldodge

    4.3 MPI Runs rough after putting in gear

    Has the fuel filter been changed? Have you checked fuel pressure?
  11. alldodge

    2015 Motor MerCruiser 4.5L 250hp NO EC - OVERHEATING!

    Welcome It looks like your on the right track to stop the overheating
  12. alldodge

    Does anyone know this part #??

    Maybe another knows where the parts breakdown for the Yam controls, but I would find a NAPA store and show them what your looking for, they should have it. Now if you have a vernier caliper, just measure it and buy online
  13. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    No Very, very rare for a coil to go bad. Folks replace them all the time, wish I had stock in the coil Co I'd be rich
  14. alldodge

    Mercruiser Alpha 1 Gen II leaking above speedo hose

    It's in the exhaust so no issue with water coming out Have fun and go boating
  15. alldodge

    rpm signal wire and est ignition

    This should help, it's a 3.0 but wiring is the same, note the Gray wire
  16. alldodge

    5.7 GXi-HF pressure in power steering reservoir

    Don't see that as a issue. Prior reservoir caps had loose seal full vented, even had a rubber disk under the cap to keep the splashing away from cap. New caps seal much tighter, so when oil heats up so does the pressure. If cap removed when hot, then when it cools back down then there would...
  17. alldodge

    What is this

    Welcome Looks like a capacitor, remove the tape and see if there is any writing on it
  18. alldodge

    Sea ray sundeck 240 won’t rev passed 2000rpm

    While your at it check fuel pressure, it should be 43 psi
  19. alldodge

    89 Mercruiser 3.0 stalls at 2000rpm

    Welcome Is this a new to you boat? How long has it been doing this? Most likely the carb needs rebuilt, the accelerator pump may not be working correctly.
  20. alldodge

    Gimball ???

    I would think it's the U joints
Top