Search results

  1. alldodge

    Bravo 3

    The Bravo is designed so it only shifts when the upper is turning (motor running). Trying to shift with motor not running is very hard The slop in the parts is not an issue because the shift shaft is removed. The center piece is slotted If it shifts hard when motor is running then the upper...
  2. alldodge

    towing capacity question

    Mine is rated for 19,680 and ya'll can get into all the what people and gear is in the truck and subtract from the total
  3. alldodge

    Random cutting out 4.3 mercruiser

    Wrong sensors, that is the gauge sensor The TKS temp switch is on the top front side of the intake TKS module is on the carb
  4. alldodge

    Random cutting out 4.3 mercruiser

    That's the diode
  5. alldodge

    Random cutting out 4.3 mercruiser

    The temp sensor is a switch. its open below 110* and closes about 130* From manual 41 the TKS module test Ambient Temp 70* = 35 - 45 ohms 20* = 55 - 70 ohms If the 960 ohms is from the TKS then its out of range but doesn't indicate a excess current issue. Might take longer to warm up If its...
  6. alldodge

    Random cutting out 4.3 mercruiser

    Added by PO for some reason and may have been for the problem your getting. Might have used Green because it would standout and also so it would be known as ground.
  7. alldodge

    Trim not working properly

    Check the trim limit switch on the port side of the drive. If it can be adjusted and it starts to work then its the limit switch. If this does not help, connect the limit switch wires together (Pur/Wht with Blu/Wht) coming from the throttle handle. This will bypass the limit switch. If...
  8. alldodge

    Random cutting out 4.3 mercruiser

    Green wires are Bonding wires and normally go from a ground buss bar to each thru hull fitting.
  9. alldodge

    2012 Mercury 9.9hp 209cc won't start

    Lots of fuel out the plug holes, would say your flooding. Need to get back into the carb and check float level and if there is a piece of crud in the needle seat
  10. alldodge

    Gen 2 speedometer connector

    Item 34 https://www.mercruiserparts.com/bam/subassembly/30862/2686/100
  11. alldodge

    5.0GL-C won’t get on plane

    If pump wasn't pumping because of some crud inside which is now clear, some of that may have made its way into the carb
  12. alldodge

    Random cutting out 4.3 mercruiser

    The temp is on the front of the intake and has 2 wires The diode is most likely the Red plug. The more I think about it, its not the diode
  13. alldodge

    Random cutting out 4.3 mercruiser

    Being TKS might have an issue with the Temp switch, diode or TKS module. Anyone of the above if it starts drawing more current, may drain power from the coil
  14. alldodge

    Random cutting out 4.3 mercruiser

    BTW which 4.3 do you have, SN is best, but at least year and type?
  15. alldodge

    Random cutting out 4.3 mercruiser

    Have you pulled the 10 pin plug?
  16. alldodge

    Random cutting out 4.3 mercruiser

    key switch maybe
  17. alldodge

    towing capacity question

    My boat weights about 1K less dry then yours and I use a 3/4 with class 5 hitch. No issues
  18. alldodge

    5.0GL-C won’t get on plane

    Maybe use jumpers and hot wire the pump directly. If it runs and fills the filter/carb then would be another issue
  19. alldodge

    5.0GL-C won’t get on plane

    Does the pump run when motor is cranking? If not, is fuse blown?
  20. alldodge

    Quicksilver 3000 throttle control button install

    Each can be different, I wouldn't know without looking at it my self. Look at the opening and see if there is something that may show which way
Top