Search results

  1. S

    1978 Evinrude, 35 HP starter will not spin the fly wheel

    Yeah, I forgot that. Never seen the assumed diagnoses but maybe.
  2. S

    1978 Evinrude, 35 HP starter will not spin the fly wheel

    Sounds like more of a seized bearing or something. We shall see I guess.
  3. S

    1985 evinrude E20CRCO misfire

    Yes, next time don't just order a part when you haven't tested what's wrong. Swapping or testing coils, plug wires.....dirty connections, the list goes on.
  4. S

    1970 4HP Johnson

    Gotta love ebay!
  5. S

    1985 evinrude E20CRCO misfire

    Get a spark gap length tool. You can get an inexpensive single one for under $10 Check spark for a 3/8 jump with a good blue snap. Most likely bad spark or crap in the carb. Don't run it with high rpm's in a barrel or on muffs.
  6. S

    60 hp Johnson won’t idle

    Did you replace all of your fuel hoses? Might just be gunked up again.
  7. S

    1988 35hp - Multiple issues

    Tranny fluid and acetone makes the best penatrating oil. Been down your road though will little success.
  8. S

    70 4 hp Evinrude recoil

    Watched the whole video....yes, easy peasy! <Eyes rolling>
  9. S

    Advice needed 1977 evinrude 35 hp

    Glad it came off....impeller is shot but like you said, good to see all it's fins intact. Time to get busy!
  10. S

    Advice needed 1977 evinrude 35 hp

    Hopefully the lower unit will come off. Pray the driveshaft isn't stuck in the crank....
  11. S

    Advice needed 1977 evinrude 35 hp

    If it all looks in good shape than I just usually change the impeller. I use a little goo.
  12. S

    Advice needed 1977 evinrude 35 hp

    Same pump kit.
  13. S

    Advice needed 1977 evinrude 35 hp

    Didn't have your exact model number but I believe this is it. Updated part number with gaskets.
  14. S

    Advice needed 1977 evinrude 35 hp

    I fixed one up and sold it this summer.....it was hard to run on muffs but I did it.
  15. S

    Engine Running Hot

    What brand of thermostat?
  16. S

    Starter not engaging after running

    Starter solenoid getting hot maybe....get it to the condition and then jump it like mentioned above.
  17. S

    New Johnson J35EL CND

    Had you just charged it when you were Spinning the motor? Have you done the other tests. Could be corroded wires, bad soloniod or bad starter. You need it to spin up correctly to get a good compression reading. If your compression numbers stay where there at you might think about get rid of it...
  18. S

    What is the function of the orifice plug

    All kinds of things but let's back up. When you run it full it's on a boat right? And not in a bucket. Turning off or starving it of fuel leans it out so yes they may lead you to believe it's running rich but it's also starving the motor of lubrication and could be doing harm to it. You should...
  19. S

    New Johnson J35EL CND

    14.5 volts on a sitting battery? Meter isn't correct.
  20. S

    New Johnson J35EL CND

    What's your battery voltage at the battery.....then voltage at the battery side of your soloniod? Then while cranking the battery, what is your voltage at the starter side of your soloniod?
Top