HP is High Performance such as X, XR and XZ drives
Your good the regular Merc, VP, OMC bearing will work
Might even find some new old stock (NOS) greaseable bearings (I stll have 2 NOS on the shelf
No
Your mixing 2 cycle and 4 cycle
Need a bit more clarification to make sure what your doing. Reason is because if the boat is a 2016 then the control and wiring will match and should already have a kill switch. Your asking so my guess (using my pea brain) is we are not working on the same...
All of the bearigs are the same for VP, OMC, Indmar, Merc (MR, pre, gen 1 , gen 2, bravo), and only difference is if you have a HP transom assembly.
What is your serial number?
To kill a 2 stroke motor the Magneto is grounded
To kill a 4 stroke motor 12V is removed from the coil
2 stroke
Note the M terminals goes to the Magneto. One of the M's connects to ground. When key is turn OFF it grounds the connection. Same thing happens when the kill switch is pulled
4...
WD40 everything, hope it will displace anything which might cause an issue later. It displaces water and left behind it helps insulate
Just my opinion, others usually differ
A Nooooooooo
Is it a carb (2BBl 4BBL), EFI (TBI, MPI)?
Is it in a truck, a car or a boat?
Does it have points or electronic ignition?
Does it have cable throttle or digital control?
Is this a new to you motor, or new problem?
Again we have NO dang idea what the HE double hocky sticks your...
Don't know first hand, but list its only 4000 lbs dry, so should do ok. Kind of light, my 23ft Rinker is 4300 and I have a single 300hp 7.4
A carry on AC is air cooled and most fit in thru the deck hatch
The issue is going thru the wires is not the same as using a volt meter. A meter would tell you if there was voltage or not so you could determine what is the issue. From your statement, the connector was pulled apart and you don't know if it was the Red/Purple or the Purple wire pin which was...
Can get the Merc alignment tool 91-80547A1 which is also used for TR and TRS drives, but there not used much anymore
https://www.mercruiserparts.com/805475a1-alignment-tool-kt-1
The Merc gimbal install tool is several items
The key one to have is the mandrel 30366 of something similar which...
