Search results

  1. Faztbullet

    1995 Evinrude Ocean Pro 200 Carbed 2 stroke Flooding out at speed

    Replace it with a ZUKI 4 stroke......
  2. Faztbullet

    Forward and reverse help!

    Is this spark test at cranking or running? Will it start?
  3. Faztbullet

    1989 40Hp mariner part finder.

    Serial number and how many cylinders? if 4 it a Merc
  4. Faztbullet

    1998 Mercury 225 slipping at high speeds

    You have a HD transducer mounted on hull or power poles?
  5. Faztbullet

    1998 Mercury 225 slipping at high speeds

    What type of boat? Sounds like set-up is off and its falling off the pad.
  6. Faztbullet

    1999 Johnson 25 carb help req.

    Sorry but you need to find a carb replacement as that is not sold separately. These break from engine harmonics. These harmonics can come from engine being overpropped,damaged prop, bent prop shaft
  7. Faztbullet

    Bad things happened today. 2001 35HP Johnson

    Ring pin migration is reason it failed
  8. Faztbullet

    Carburetor question on restoration I’m working on 1992 40 hp MSHQ Yamaha

    Never seen a 3 cylinder Yammy of any HP with fuel pump on carb. That motors pump is on block. Find a older Merc or Johnson tank and ditch the EPA junk. These new tanks build up so much pressure if you dont unplug them and use demand valve, it will flood motor as pushes needle off the seat. Also...
  9. Faztbullet

    Yamaha 15 mounted too high

    Fact ...The distance between the upper splash plate and AV have NOTHING to do with performance or mounting height. So give your BS on tall and short gap plates a rest. Below is straight from Yamaha manual........"motor to low increases drag and reduces efficiently". When you bury the prop/lower...
  10. Faztbullet

    Yamaha 15 mounted too high

    A lil deep in my book, install a 1x1 wood block under bracket to raise it and retest.
  11. Faztbullet

    evinrude qiuck start

    Ground the wht/blk from pack to the block. if it comes out after starting the sensor or temp on that cylinder has a problem. Quickstart will always be engaged when started but should drop out in a few seconds on a hot warm engine.
  12. Faztbullet

    73 1150 fuel pump/flow question

    Make sure you installed the correct diaphragm kits as they look the same but gaskets are different
  13. Faztbullet

    Gas pouring out of oil dipstick spout

    Drain and flush engine and check fuel pump. If tank overpressurized it either flooded engine thru carb or split the diaphragm in fuel pump
  14. Faztbullet

    1989 mer alarm

    What HP and year?
  15. Faztbullet

    DVA stator testing

    Cause it not a Yamaha and calls for surface gaps
  16. Faztbullet

    1986 Yamaha 25hp doesn’t run good under a load

    If you squeezed primer and it picked up RPM it not a prop problem. Nor will a spun or slipping hub cause it to be bogged down, just the opposite. You have a carb or fuel delivery problem.
  17. Faztbullet

    DVA stator testing

    Either #3 carb is acting up or ignition is firing late will cause it to be black. You can swap coils and see it weak spark follows coil. Check the keyway first. Put #1 at TDC and see where points shows on flywheel.
  18. Faztbullet

    DVA stator testing

    "Would indexing and checking with a timing light also test other potential problems?" Yes...like sheared key, misfiring switchbox...have you done a correct sync and link on carbs???
  19. Faztbullet

    DVA stator testing

    Index the flywheel and check timing on each cylinder. The idle staying high and runs like crap makes me lean toward a sheared flywheel key
  20. Faztbullet

    DVA stator testing

    If the miss is at idle and DVA reading is fine on low speed its not the stator. High speed does switch over till around 2000RPM in switchbox.
Top