Search results

  1. alldodge

    7.4 MPI Fuel pressure regulator/damper?

    Do search around, as FT mentioned its a GM part. I search on just the old number and found it at Walmart and Amazon for 170 or so. Sierra has them for less Should be a cross over to Mallory of Standard
  2. alldodge

    Replacing Porch Post

    I have a 10 brake and can bend the aluminum around, but in most cases it won't look as good as a factory snap around kind of thing Agree, would use spacer between wood and concrete Thanks
  3. alldodge

    Mercury throttle help please

    Assuming its newer then 1994 I think its the roller detent item 66 In the link you will find all the controls for 94 and up https://www.mercruiserparts.com/remote-controls-and-components-1994
  4. alldodge

    Mercruiser 3.0 MPI 2016

    If a scanner is placed back on it, watch the TPS volts and IAC position
  5. alldodge

    Electrical short 4.3 Mercruiser 06Tahoe

    The TPS is on the throttle body (TB), the IAC is either on the TB or the intake Again, I need a serial number
  6. alldodge

    Mercury throttle help please

    That's some nice close up pics, but I need one further away showing the throttle handle and/or throttle handle model number
  7. alldodge

    2002 5.7Gi-BF wiring harness connector damage, fuel pump dead

    With your fuel pump not turning ON I would check fuses. Not familure with the 570, is that a Ford or GM? The Gi 10 pin is in pic and you can buy a new pigtail and solder in place.
  8. alldodge

    Electrical short 4.3 Mercruiser 06Tahoe

    When asking a question always best to provide the motor serial number, this way we know what your working on The 15 amp fuse should be 12V main power. Things that draw direct from the fuse are the main power relay (MPR), power control module (PCM), idle air control (IAC), and throttle position...
  9. alldodge

    Volvo Penta TMD22

    Howdy Black smoke means more fuel then the motor can burn. Things that cause this issue are: Clogged air filter Waste gate stuck open so turbo cannot build pressure Low compression Blowing black smoke in neutral I would have a compression test done. This needs to be done by a diesel mechanic...
  10. alldodge

    Replacing Porch Post

    Maintenance free to me means no painting, but only painting post every few years isn't bad. I've already used my break and covered everything else with aluminum Think I'm going to put original post back and then look into a vinyl or aluminum wrap. Current color of everything else is a musket...
  11. alldodge

    I am finding contradicting information on wiring a charger and a inverter to a 3 battery system

    This is my take using one inverter/charger (inverter does both charging bats and makes AC). The ACR will charger both banks when motor is running or when plugged into shore power. If your using separate chargers and inverters, just connect the charger to the start bat and ground What do you...
  12. alldodge

    Removing Bottom Cowling on 1997 Force by Mercury 75hp

    The exhaust is attached to the bottom of the block. After removing the rear cover below the cowling you can get at bolts holding the motor. There are also bolts around the motor in front. Don't know which motor you have but here are some pics of my 125 Chrysler
  13. alldodge

    Mercruiser 3.0 MPI 2016

    That sounds terrible, like gears and metallic type sound. What happens when its reved up higher, like in throttle only mode? Need to scan the motor for codes
  14. alldodge

    1968 MerCruiser 120 sterndrive water pump

    Since your seeing water spilling out around the muffs, it could just be they are not sealing very well. Its normal to see a lost of spill before motor is started. After starting the water should reduce a lot If your gauge is accurate then your good
  15. alldodge

    1968 MerCruiser 120 sterndrive water pump

    The heat of the motor has nothing to do with how much water will exit the exhaust. As before, it either goes straight out the exhaust, or some goes in the block and what goes in the block gets pushed out the same amount out the block and to the exhaust
  16. alldodge

    I am finding contradicting information on wiring a charger and a inverter to a 3 battery system

    Then you need a 2 bank charger and a ACR. The start bat remains the same, just need to add the ACR and connect the house circuits to the dual bat
  17. alldodge

    I am finding contradicting information on wiring a charger and a inverter to a 3 battery system

    Howdy Being a 24 footer it should be a single engine so one alternator Does it have a generator, and how do you want to connect the 3 bats? What is the load on each?
  18. alldodge

    Mercruiser 3.0 MPI 2016

    Vids work best when using things like youtube and link back here by by using the camera link
  19. alldodge

    1968 MerCruiser 120 sterndrive water pump

    Feel under the bottom of the transom assembly at the corners
  20. alldodge

    Replacing Porch Post

    Thanks, the ones that are there now are treated pine and still straight. Home was built in 07 so not bad
Top