Search results

  1. alldodge

    Chrysler 105 and 125 combo Maybe

    Back in 2015 I picked up a Chrysler 105 Conqueror with a 105 hp OB. Well the OB had a cracked block so could not use it. Frank mentioned before his passing that I should look for a pre 1994 Force 120 hp and swap the cowling. In looking I found what I thought was a 140, but might just be a...
  2. alldodge

    Bilge pump float switch install

    A bilge pump should be hard wired direct to the battery thru the float switch. The switch at the helm should only be there to run it in manual mode. In the pic below the switch supplies power to the pump from the helm for manual mode. The alarm can be a light or sounding device, but not necessary
  3. alldodge

    Alignment made so easy, Should have tried sooner

    Short answer but long story, but if Ya don't want to read it go to the bottom I bought the Merc part 91-863372 a couple years ago and never used it. I managed to get it real close without it so (thinking to my very Naive self) , said self "your good, no need to get the tool" and moved on. The...
  4. alldodge

    2000 5.7 gsi problem

    If you have at the coil and unsure at the plugs, then this doesn't need to be confirmed so much. But if your unsure of the coil also, then suggest getting a remote starter switch. You can turn the key ON, then use the remote to crank over the motor. Culd also use a screw driver to jump across...
  5. alldodge

    Volvo Penta Overheating

    Since the impeller shreadded, I would ask did you find all the pieces? If this is unknown, did you back flush the cooler and look inside to see if things were hung up? Is this a fresh or salt water boat?
  6. alldodge

    Looking for Delphi Numbers

    Anyone have a listing of the Delphi numbers which correspond to MEFI numbers? Have a MEFI 1 and always thought it came from my old motor, but just did notice the Delphi number is for a 350. Not that this is an issue because its my understanding that they can all be reprogramed. Did call AZ and...
  7. alldodge

    VelvetDrive Transmission leaking fluid from dipstick

    I doubt it, and probably because it was analog and when motor was installed then didn't change/add/replace the sensors in the trans. The cooler would need to be removed and flushed out with something like diesel, then reflush once clean with Dexron There is a drain plug in the bottom of the...
  8. alldodge

    transom leak

    Need to select message title
  9. alldodge

    350 Mag Exhaust manifolds getting hot

    The S/N helps With open cooling you can have either 3 or 7 point drain system. The 7 point system s below uses check balls in the thermostat housing which go to the risers. These check balls slightly restrict the water flow to keep the manifolds full. If they get weak, then more water goes out...
  10. alldodge

    Need help removing throttle shifter

    Have the same on. Push in on the little black dot with something like Phillips screw driver, then lift up the chrome piece on that end. It pivots open and off.
  11. alldodge

    Need some advice on what I've got

    I would believe these are older barge navigation lights. They had a long cord to run them up to the front barge on pushers, or hang along the cable towing one Now days they use long life rechargeable ones
  12. alldodge

    what diode for running anchor light switch

    The big issue is the forward current and that's 1 amp for the diode selected. The regular incandescent 12V lamp can be more then 1 amp. If your using LED then its much less. Look at the bulbs watt rating. A 15W bulb pulls 1.25 amps. Formula P=E x I P=watts E=volts I=amps I = P/E or 15/12 =...
  13. alldodge

    waterproof electrical plug box on a lamp post

    Think your looking for something like this which is rain tight http://www.electricbargainstores.com/product-p/RAB-TACB.htm?gclid=Cj0KCQjwkd3VBRDzARIsAAdGzMBpSbx4UoeGrAUs8chwmx6YZmkkAP3oIRUGux58IR38q3jK05uPzrAaArMIEALw_wcB but assuming this will be plugged in all the time. Could use a water...
  14. alldodge

    More 87 Mercruiser 3.0l problems. help........

    I think your manifold is cracked As for the freeze plug, it shows 2 and both illustrate on the port side http://www.mercruiserparts.com/bam/subassembly/30912/963/290
  15. alldodge

    1979 OMC 140 Sterndrive mounts are out...

    Howdy Need to post a few more times before you can upload pics If your talking about the front motor mount and the lag screws that go into the stringers, then you have hull rot
  16. alldodge

    More 87 Mercruiser 3.0l problems. help........

    Not real sure of the location you mentioned. If the water is leaking from the riser boot (position 1), then it should be warm, but should not be leaking. Suggest get some clear hose from local hardware store and put inline with the hoses. This will show where the water is going and also not...
  17. alldodge

    2012 Cadillac SRX P0442

    The Admirals Cadillac (110K miles) thru a P0442, which can be (from what I read) a vacuum leak in the tank, lines, purge valve, vent valve or canister. Jacked the car up and looked all over the place and could find nothing which stood out. First thing to check was the gas cap. Web says the...
  18. alldodge

    2006 Mercruiser 350 BIII Hot Manifold?

    The replaced 2 gaskets comment leads me to believe they were the wrong ones, otherwise why were they replaced :noidea: Here is what the gasket should have looked like This is for closed cooling
  19. alldodge

    2006 Mercruiser 350 BIII Hot Manifold?

    Just realized something, your first post comment of the "starboard" was meaning that this is happening on the starboard motor, NOT the starboard manifold. Thie pic posted looks like this is the port manifold of the starboard motor, correct? So water should be moving from the bottom of the...
  20. alldodge

    2006 Mercruiser 350 BIII Hot Manifold?

    Thanks for the serial number. Your not getting sufficient water coming into the bottom of the manifold to keep it cool. This can happen with either to much restriction or to little. Water being feed to the risers comes from the manifold and also a hose with a built in restriction. The...
Top