Search results

  1. R

    1979 Mercury outboard

    Should be a few on E-bay I think.----Or find a parts motor on Craiglist / facebook market place.
  2. R

    1979 Mercury outboard

    Mercury.
  3. R

    59 golden jubilee 5.5

    Sorry----I can not see the parts you have.-----I have lots of shifter forks here.
  4. R

    59 golden jubilee 5.5

    There is no adjustment feature.-----Your replacement shift rod is faulty or clutch dog / gear are bad.------Good luck with it.
  5. R

    1979 Mercury outboard

    I doubt FORCE motors used oil injection.---Post pictures and it can be identified in seconds.
  6. R

    1979 Mercury outboard

    ???----FORCE motors were not marketed in 1979.
  7. R

    59 golden jubilee 5.5

    I would say you need to replace clutch dog and forward gear.----Or PRECISELY grind off the correct material to restore surfaces on those parts
  8. R

    59 golden jubilee 5.5

    Where did you get the shift rod ?----Part # of it?---It is a wonderful design with no chance of it going out of adjustment.----It can only be the forward gear and clutch dog as the issue.
  9. R

    BMW headlight . . . $1,000 !!!

    I remember the days when you walked into the parts store.----A 2 lamp or 4 lamp system was the choice.----$5.99 and you walked out.----Then 3 little screws and changed it out.-----Modern stuff is not cheap !
  10. R

    Engine height

    Post model # of this motor.-----Measure the height of the transom and post the exact dimension.
  11. R

    What year is my mariner

    New to you motor ?-----What is the motor doing / not doing ?----What trouble shooting has been done if any?
  12. R

    Johnson 150 gear reduction starter

    Nothing scary about taking the cover off.
  13. R

    Roll pin

    The pin comes through a slot in the housing.-----Those parts stay up there.----On a 50 year old motor it makes perfect sense ( to me ) to remove the power head to inspect those parts.
  14. R

    Roll pin

    The roll pin drives / turns the mechanical seal.----And it is used for both long and short shaft.-----I say remove the power head and replace #1 and #3-----Inspect #4-----Refinish #2.
  15. R

    modifying a crank rated 9.9 into its shaft rated counterpart?

    Not sure if they changed the rating on the 9.9 / 15 models.----Perhaps they did in 1993 when displacement increased on the 9.9 / 15 HP.
  16. R

    1970 6hp Evinrude 6003B Shear pin.

    Correct----Rubber hub.-----A wise fisherman might use a brass pin.----Have 2 brass spares in the tackle box.----And a third spare is the steel pin.
  17. R

    Engine height

    Do you understand the difference between tilt and trim?-------When tilting the motor DOWN it goes fast.-----It appears to stop.------Then slowly trims all the way down.------I believe you are running and not having trim all the way down.-----Or hurry to a shop and have them show you.------Had an...
  18. R

    1957 Johnson 35hp short to long shaft

    To be reliable / daily runners , both these motors should be taken apart.
  19. R

    Little thingy with red lever

    A 1973 model did not come with this electric primer.----But perhaps someone retro fitted one.-----Pictures will help you get answers.
  20. R

    Manifold leak

    They made thousands of these motors.----No need for better screws at all.----Replace the gaskets.
Top