Search results

  1. C

    Help diagnosing no start

    well wires usually go somewhere.... what is the consequence of leaving them open and taped up. did you ever get the service manual downloaded. It has lots of info and diagrams you can look up. if you get engine & the solenoid working in neutral .... from the key you are all set...
  2. C

    Help diagnosing no start

    If I turn the key on, I should be getting 12v at the S- white wire on the ignition switch, right? no... you only get 12v on the S when the key is at START ! at key ON only the A post (sometimes purple) has 12v see diagram above. for power transfer inside the key at various steps...
  3. C

    1965 Evinrude 9.5 Throttle Issue

    the mag plate should rotate on it own if the linkage is not hook-up to it and kill wires to the switch do not snag. if ok then the linkage is not installed properly ...one problem I had was setting up the mating teeth in the throttle and a worn part
  4. C

    1965 Evinrude 9.5 Throttle Issue

    did you do coil work in case they are not set in properly and snag on the FW ??
  5. C

    Help diagnosing no start

    ex: with yellow-red START wire
  6. C

    Help diagnosing no start

    I have the ignition switch out and trying to test it for continuity but honestly can't find decent directions. My switch has terminals labeled battery s (STARTER CONTROL USUALLY VIA NEUTRAL INTERRUPT SWITCH OR DEVEICE) a ACCESSORY USUALLY PURPLE BASICALLY PROVIDES B+ WHEN KEY IS ON) and two m...
  7. C

    1965 Evinrude 9.5 Throttle Issue

    see document https://www.leeroysramblings.com/OMC_9.5.htm https://www.aomci.org/forums/topic/1965-evinrude-9-5hp-9522c/
  8. C

    1965 Evinrude 9.5 Throttle Issue

    recheck your lever and pin follower that rotates when the underside of the mag plate turns against it . I had mine installed incorrectly and had a similar jamming problem did you try rotating the side idle adjust knob for more leeway on the linkage
  9. C

    1957 Johnson 35hp short to long shaft

    to service your oldy all you need in is in this book...cheap for 600 pages $20 https://watercraftmanuals.com/outboard/johnson/manuals/johnson-302231.htm
  10. C

    1957 Johnson 35hp short to long shaft

    see personal message in small enveloppe top right before spending to much $$$$ do basic checks ... like compression . https://www.duckworksmagazine.com/06/columns/max/articles.htm visit AOMCI site where oldies are the main focus..lots of support available under ASK A MEMBER ...
  11. C

    Help diagnosing no start

    voltage readings are veny iffy at best if no amps flow to energize the solenoid ..... you can have12v all day and nothing happens without amps . if a manually applied strong B+ makes the solenoid work ok the 12v from the key is resistive and by ohms law max volts and amps will drop at...
  12. C

    Help diagnosing no start

    first thing is to state the HP... model-year number second is look for any fuse if provided in the diagram which could... be found here https://maxrules.com/JOwireindex.php no click on the solenoid and 12v is present on the control post when key is at start.... can be bad solenoid , bad...
  13. C

    1994 88 SPL overheat alarm at WOT

    see conclusion to a long story and... ridlyme... https://www.etecownersgroup.com/post/pesky-overheating-issues-13573754?trail=30
  14. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    if you do use heli coil inserts just make certain your insert is not long enough to extend past the thread normal area inside the and outside . Inserts come in different lengths follow procedure to install and punch it properly to lock it in place
  15. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    carefully unscrew the bolts (don't break any !!) if to stuck try some heat on the bolt head and wd40 to seep in the bolt head... a sharp knife blade between the head and frame should release it.. scrape clean the cyl head and engine block . check the water jackets for crud and clean...
  16. C

    79’ Evinrude 70 Bogging

    sounds mysterious that you would need to increment the jet size after all these years unless a big altitude change took place. but if it works great !!
  17. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    surely yet $$$$ on this oldy for an hour's labor ($100-125) OP could by a gasket and helicoil kit. as a first time job . keeping shavings out of the cyl would require grease and practice.
  18. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    you will need to pull the cyl head and install a helicoil using the proper kit. use full metal inserts not the spring looking type. use some red lock-tite kit comes with a proper size drill tap and inserts did it on a 7.5 and all good.
  19. C

    1972 Evinrude 9.5(Model 9222m)- no spark

    https://www.aomci.org/wp-content/uploads/attachments/1972%20Evinrude%209.5HP%20Service%20Manual.pdf
  20. C

    1972 Evinrude 9.5(Model 9222m)- no spark

    compression on these is usually upper 60s and 70s not much more but they work fine while working the magneto don't forget a drop or 2 of oil on the small felt pad rubbing on the crankshaft ) I use 2 drops of sae 90 GC oil to soak the pad. btw try disconnecting the kill wires to the...
Top