Search results

  1. C

    1988 Johnson 30 hp not pumping water after water pump and thermostat change.

    tried sending some hose water up the water tube....should come out somewhere ! if not something is blocked upside
  2. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    the old bypass cover has a slanted shape to guide the incoming rush of fuel air mix towards the cyl ports. Useful or not ? it was design intent so I would leave them in place and just mount the aluminum plate over it. You may want to flatten the bypass cover dead plat until shiny to...
  3. C

    Johnson 1987 J48ESLCUS red plug/harness to controller question

    well... from here... one looks black... ground Tan.....temperature Gray... tach if the connector has no mate going anywhere on the engine and performance is not affected then it is optional. where exactly it is located ? post a clear picture of surroundings
  4. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    actually it is not that complicated to mount on a aluminum plate about 1/16 or 3/32 inch thick plate with a 1/4 hole directly facing the back of the square pump pulse hole and the plate itself mounted over the existing by pass cover itself drilled 1/4 inch behind the plate hole behind the...
  5. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    if you plan to use the air barb behind the carb you MUST follow the video and seal one channel and remove the flapper valve. This is why using a bypass cover from a 60s engine with proper moldings to mount the square pump is so easy . other wise see pictures on how to get a...
  6. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

  7. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    That Kohler pump is for 4 cycle engines like lawn tractor etc... and has been known to cause some grief. up to you some don't like cheap OMC square copycats from China but i haven't found them to be that bad... if you get everything set up and wish to go full OSM pump you can always do so...
  8. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    As per racerone... check thermostat see what I found on a 6hp project currently underway. Condensers were tested good :) at 275V Points look new or certainly useable. here is a good link with lots of info for you https://www.leeroysramblings.com/ see western region aomci articles on...
  9. C

    1978 35hp johnson 35853R

    lawnmower did one of mine took 10-11 to grow back so be patient 3 toe tips did not make it and one shoe . did not hurt for about 2 seconds then all hell broke loose
  10. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    i just picked one up yesterday 75$cdn :) lacked some TLC but hopefully will run good. I prefer fixing them up instead of sinking white balls in holes in the grass and I get to keep/resell the motor.
  11. C

    1977 85 H.P. Evinrude Model # 85895C S# J0003143. Low idle issue.

    same question then any chance a problem could develop at that level ?
  12. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    found some info on red ATOM 215's the ones to use but.. NLA :-( btw I never had any problems with OEM set up and tuning with a VOM.... just saying
  13. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    any links to source these modules $$$ ??? etc... Mag ingnition has been around for all these years and isn't that bad considering but if modules are cost effective .. a lot of these oldies are perfectly fine and were used few hours /summer on trips then stored away most of their lives.
  14. C

    1977 85 H.P. Evinrude Model # 85895C S# J0003143. Low idle issue.

    hard to see on parts list but does this animal have any recirculation hoses or possibly plugged up recirc hoses ??
  15. C

    FICHT ...code 38

    not mine ....just asking... owner stated he get's enough pressure (PSI) to cause the sensor to open as it should. for some reason the EMM declares code38 which normally indicates missing pulses. With justa single wire to the sensor seems that sensor must provide some form of pulsing ground...
  16. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    this what you find under the fw... themotor likely needs new condensenser ... points may be burnished but in doubt... replace and time per this video may as well install new plug wires and boots to ! lots of utubes on the subject . I use Belden automotive plug wires with metallic strand...
  17. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    another installation plate over original bypass cover plate ........pump is off-set a bit . don't forget to plug the air pressure nipple behind the carb note: some pics not mine .. the round pump with gold mesh has given problems apparently so best o use square Mikuni or OMC pumps
  18. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    see pic
  19. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    I have an identical one at the cottage.. easy to convert and has Racerone suggested if you can find a 1960s+ transfer cover it becomes a piece of cake to convert by simply installing an OMC square pump. then change the side connector for single line hose . If you can't find a side cover...
  20. C

    FICHT ...code 38

    Would anyone on here be familiar with code 38s NO OIL on a FICHT 200hp 1999 Pressure sensor checks out OK within specs and opens (infinity) above 5psi oil pressure yet the EMM falsely declares code 38 (missing oil pulses after x min/seconds) . oil pumps OK no wire chaffing on...
Top