Search results

  1. flyingscott

    1976 Evinrude 35 hp flywheel issue

    Was everything pushed back to the edge of the bevels?
  2. flyingscott

    1976 Evinrude 35 hp flywheel issue

    No but pop the flywheel and make sure nothing is rubbing. You may need to adjust things under there.
  3. flyingscott

    Fuel Regulator cross ref or sub numbers

    I don't know why you can't get it. I looked up the part online and found at least 2 of them
  4. flyingscott

    97 tracker 120 starting only at full throttle

    Check spark and compression.
  5. flyingscott

    Question on starting an outboard. And fuel line question(s)

    Your fuel line leaks because you have a mercury fitting on the hose. They look similar but do not work with each other.
  6. flyingscott

    Loose flywheel magnets

    Evinrude did make a kit to repair them. 0431929
  7. flyingscott

    1993 Evinrude 150 no spark

    Tether switch connected? If you had spark why replace all those parts.
  8. flyingscott

    1994 Astro S-18FS (won't start)

    That motor has a pretty good injection not prone to failure. The 2+2 is a good motor.
  9. flyingscott

    1994 Astro S-18FS (won't start)

    That switch under that little cover is your Deadman switch. Only get the factory manual for that motor. It will also cover the 2+2 operation
  10. flyingscott

    1994 Astro S-18FS (won't start)

    How do you choke tat motor? Do you push the key in? How did you check for spark? Have you done a compression test. You need to buy the factory manual for your motor
  11. flyingscott

    1994 Astro S-18FS (won't start)

    Put up a pic of the controller in the boat
  12. flyingscott

    1994 Astro S-18FS (won't start)

    Check the tether switch on the controller
  13. flyingscott

    2006 Mercury Optimax 175 issues

    But that motor you are tied to the dealer. Just the nature of the beast. Or you can try to buy a scanner for it.
  14. flyingscott

    2006 Mercury Optimax 175 issues

    That's a bad motor to not have the funds for as parts are generally expensive. First thing to do is buy the factory manual. You need to see if it is storing any codes. But a good bet is the motor is the reason it ended up at auction.
  15. flyingscott

    25 hp (1976ish)Merc shifter rod

    And make sure the Orings are on that piece it is your seal.
  16. flyingscott

    25 hp (1976ish)Merc shifter rod

    Remove the waterpump assembly completely. Including the lower plate. When is out of the way you will see the hole it fits in. Push it down in the hole with the tall post positioned under the pump baseplate. Might be a screw for it somewhere in there. Hopefully the shif y rod was not pulled all...
  17. flyingscott

    2000’s merc 90hp 2 stroke

    If it's a 2000s you will need the manual to trace the kill circuit. I believe the 2000s have CDM modules.
  18. flyingscott

    Buzzer won’t Stop

    Disconnect the oil tank sensor. Those are notorious for failing.
  19. flyingscott

    10r77a rich lean adjust

    Turn until you get a lean sneeze then back out 1/4 turn and fine tune from there.
  20. flyingscott

    10r77a rich lean adjust

    1.5 turns out should get you started then you can find tune it after it is warm
Top