Search results

  1. R

    9.9 dies after pushing in Choke

    Clean the carburetor.----And run fuel out of the carburetor at the end of the boating trip.-----An empty carburetor stays clean.
  2. R

    58 evinrude 7.5 cooling problem

    Did you put the copper tube into the upper grommet first.------And then install the lower unit ?
  3. R

    This proves it

    Agreed.----Designed to snap together at the assembly line.------No consideration for quick affordable repairs.------Remember the days of the round and rectangular headlights.-----Scary what it costs today to replace one headlight assembly.-----See the video of the TESLA battery at $ 22,000 to...
  4. R

    58 evinrude 7.5 cooling problem

    The water in your test bucket MUST be 8" above the impeller.
  5. R

    Loss of power, won't plane

    Remove any ring bits embedded in that head.-----Use small ball peen to knock down any bumps.-----Both heads are warped to some degree.----They all are.----So refinish it with a piece of glass and valve grinding compound.-----Then reuse it..----There will be no issue with it.
  6. R

    Towing Boat In Cold Temperature

    Perhaps consult with -----Airbus and Boeing-----They build aircraft with composites these days.-------Fairly cold at 35,000 feet I hear.
  7. R

    Loss of power, won't plane

    Yes you have to pull the powerhead off.----I used to be able to lift one of those powerheads off by myself.-----That is when I was the highschool wrastling champion.-----Powerhead does not weigh much much more than 120 lbs once you have the flywheel and starter off.-----And , yes you need 4 NEW...
  8. R

    Loss of power, won't plane

    See post #2 on this.----Correct as clearly stated this----BROKEN RING SYNDROME -----Is very common.-----Your motor has the disease.-----Needs to be torn down for rebuilding.----Many will not believe it , I see this damage all the time.-----Easy fix for me.
  9. R

    1998 johnson ocean runner 200hp j200txecm fuel bulb needs pumped at low idle or will stall

    I would begin with an inspection of your fuel system from the pump to inside ( pick-up tube ) the tank.----Also the anti syphon valve if equipped with that.-----Or test run the motor on a known to be good portable 6 gallon tank and hose.
  10. R

    Reattaching an oil pump (and reservoir) too a 2004 Yamaha 50hp 3cyl 2 stroke?

    But , but ----When the motor is running the parts will be covered / coated with oil.-----That is the only way parts can be protected from wear.------So when the carburetor runs out of fuel only DRY air goes through that cylinder.-----The cylinder produces no heat / no power.-----My point is that...
  11. R

    1990 Yamaha Pro 50 2-Stroke - trouble starting, now it won't start

    Your starting issue has to do with the starter / choke primer solenoid.-----Are you pushing the key in and holding it in while cranking.----Or post a step by step of the procedure you are using to start this motor.------I had to coach an individual last year on starting an older motor.-----Had...
  12. R

    Newbie looking for advice

    Bowriders do not do well at the ---Haulover Inlet-----Look for the videos on youtube.
  13. R

    Reattaching an oil pump (and reservoir) too a 2004 Yamaha 50hp 3cyl 2 stroke?

    There are numerous posting on oil / ratios / fouling of plugs.------Postings where they say it is bad to run a multi carburetor engine out of fuel .---Say that some cylinders will be running with no oil during that procedure.-----That simply leads me to say that many folks do not understand the...
  14. R

    Newbie looking for advice

    There are some " timeshare " boating clubs.------Look for one in your area.------They own say 10 or 12 boats.------You pay an annual fee plus for the time you use one.-----A competent person looks after all the details ( insurance , maintenance ) ETC.------Cheapest way to go boating !!!
  15. R

    Is fogging oil different than it used to be???

    The fogging is done on older 2 strokes to coat all the bearings on crankshaft with lots of sticky oil.-----A can of storage oil should do for about 5 seasons on a V-6 model 2 stroke or a V-8 inboard.----But as stated there is a lot of overkill done on winterizing.------Had an individual call me...
  16. R

    1977 Glastron 175hp 175hpv “Free Boat” project

    A compression test is the first thing to do.-------Spray some storage / fogging oil into each plug hole with piston near the top.----You want them all the same around 120 PSI.-----Many folks would say " Just buy a new 4 stroke"----I for one think that an older / easy to maintain 2 stroke is...
  17. R

    Sea Rayder F16: low speed, smoke on idle, loud

    A stroke engine will smoke.----Using a different oil may help reduce the smoking.------But I have said it many times ---" the whole concept of oil mixed in gasoline is not well understood "
  18. R

    Engine Mount Trolling Motors

    Perhaps you should look at the parts diagrams of a 1962 and a 1964 model !!----You will see that the 62 and 64 had the same bearings as well.----This whole concept of oil in 2 strokes is not well understood.
  19. R

    Reattaching an oil pump (and reservoir) too a 2004 Yamaha 50hp 3cyl 2 stroke?

    In 2004 they did not offer the 50 HP as a ---" mix your own " set up.
  20. R

    Engine Mount Trolling Motors

    That looks like the electric shift model.------A bit thirsty but a great running motor.------It will run just fine at 50:1.------Many ways to connect a trolling motor to the main motor for steering.-----Lots of things to look at to make that wonderful motor as reliable as a new motor.-----No...
Top