Search results

  1. nola mike

    4.3L Mercruiser Milkshake

    If it includes the pertronix kit then yes.
  2. nola mike

    Mercruiser 260 Backfire Through Exhaust

    Do you know if the heads are even bad? Could pick up a set at the junk yard for $50.
  3. nola mike

    Mercruiser 5.7 carbureted wont start when warm

    🤦
  4. nola mike

    Boat turns over but will not start

    Not sure why people think that ethanol makes gas bad. It doesn't. ANY gas that sits oxidizes and loses the most volatile components through evaporation. Pretty sure there were plenty of cars and boats that didn't start prior to the 90's.
  5. nola mike

    Overheating issue.

    How did you verify this?
  6. nola mike

    Struggling with Gauge Temp

    Also have you checked the temps with something aside from your gauge?
  7. nola mike

    Mercruiser 260 Backfire Through Exhaust

    He's got it in both banks though
  8. nola mike

    Mercruiser 5.7 carbureted wont start when warm

    Sounds more like he's running rich. Did you read the thread?
  9. nola mike

    Mercruiser 260 Backfire Through Exhaust

    He already pressurized them, that's how he knows it's leaking. I think he'd need to remove the heads, install block off plates over the water passages/top of the block, and pressure test just the block.
  10. nola mike

    In dash GPS speedo?

    My pitot got ripped out when the boat swamped. Was going to replace it until I realized that gps was more accurate and I could fill my hull penetrations from the pitot.
  11. nola mike

    1985 3.7L 470 170hp mercruiser

    Very, very unlikely. Stringers and transom as well as floor are wood. Not sure if any boat if that era used composite
  12. nola mike

    1985 3.7L 470 170hp mercruiser

    So much more to look out for in a neglected 470. But first is the structure. You need to pull up the floor, check the stringers, and drill some holes in the transom to check for rot before you sink any more money into this thing ...
  13. nola mike

    New to boats and about to burn down my boat. Need some help with wiring.

    Again, afaik no denso ignition systems in the 4.3... Someone correct me if I'm wrong. Yes, it can Don't know if they were installed on the Merc spec'd carb motors, but yours wouldn't use it. Is this the original engine? Maybe post some pics of your ignition setup. Edit: rereading this, maybe...
  14. nola mike

    New to boats and about to burn down my boat. Need some help with wiring.

    No such animal to my knowledge. TB V maybe? Post a serial number, or at least engine year and we can help you better...
  15. nola mike

    2003 25 hp merc 2 stroke impeller replacement

    Did I offend?
  16. nola mike

    2003 25 hp merc 2 stroke impeller replacement

    Took it out today with the kids, 22 mph cruising, 25 Max. Checked compression when I got back...65 psi. Waiting on 2 stroke timing light. Here's a pic of the linkage :
  17. nola mike

    Size of outboard

    Talk about a showoff, @Scott06. You have like, 230hp! I agree though, 70 hp IS pretty ostentatious. /s Also, the difference in price between a 20 yo 40hp and a 20 yo 70hp is less than the gas money needed to launch it. Still waiting for the "I have too much power, and can easily get on plane...
  18. nola mike

    Solar Power Installation . . .

    What about all the electrical gremlins?
  19. nola mike

    Carburetor Compatibility Merc 2bbl 3.0 for my 3.7

    Fair, but just like putting any non-stock carb on an engine, it would work fine if tuned correctly. But either way putting one on a poorly running engine in hopes of it running better isn't the best strategy...
  20. nola mike

    Stingray 208 water in the engine room

    A gallon isn't going to hurt anything.
Top