Search results

  1. alldodge

    Erroneous oil change warning?

    I think Fords are the worst for oil change notifications. Buddy has a 2022 F3500 with under 6000 miles and the truck ask for an oil change every 6 months (we think). There is nothing in the manual so far as when (mileage or time)
  2. alldodge

    Loosing Faith in Humanity . . .

    My neighbor was selling his fishing boat, hardly used 30 hp tracker on MP. Had two calls showing real interest and one said ok I'll be coming on X day. The guy doesn't live here so he travels down 4.5 hr trip. Guy doesn't show and says decided to go another way The good thing is he did sell it...
  3. alldodge

    4.3GL VP Fuel Pump Issues

    30 has full time 12V and need to see if 87 gets power when 12V is applied to either 85 or 86. I say either because the manufacture could use either one for 12V and the other is ground. Should be a yell/red wire on one side and black on the other. Apply 12V to yell/red and see if 12V is at 87...
  4. alldodge

    4.3GL VP Fuel Pump Issues

    Welcome Great testing procedures 12V on 30 and 12V at/on fuel pump wire when cranking I think the issue is with ground or your testing method is in error. There is 12V while cranking but pump does not run.
  5. alldodge

    High Copper and Lead in Cat 3406E

    Welcome My finds are the copper is to high. Normal is below 30 ppm so agree it indicates bearing wear. Either not taken care of or incorrect lube.
  6. alldodge

    Q5 bilge pump

    Take some measurements, my guess is you have a 500 Here are the dimensions for some Johnson bilge pump cartridges: Johnson Pumps 05503-00 12V 500 GPH Cartridge Combo: The package dimensions are 7.68 in x 7.24 in x 4.61 in, and the item dimensions are 7 in x 4.5 in x 7.5 in. Johnson Pump...
  7. alldodge

    Error closed loop gasoline bank 2

    Try this with the key ON and motor off, measure voltage on both sides of injector #3 on left bank. You should see 12V on each side of the 2 pin injector connection. If one side is 0V and not 12V than there is a ground being applied If there is 12V on each side of injector #3, remove the...
  8. alldodge

    Mercruiser 3.0 EST timing issue

    Welcome, and sorry no one responded The EST ignition is one of those mystery system that doesn't have a clear test method to determine what the issue(s) are. Many have had same problem and in most cases it's the module, band new ones can be bad out of the box This is the only test for distributor
  9. alldodge

    Tonneau Cover

    Thanks
  10. alldodge

    Penta V6-280 alarm in with DTCs 1155 and 1157

    Welcome The dealer should know better but if they fogged the motor then the fogging oil would have coated the O2 and other sensors. This can cause all kinds of problems. Don't know if the dealer would admit to it if they did. Do check fuel pressure and see if it's 50-60 psi.
  11. alldodge

    Bravo 3 Lowering

    Welcome Most likely it's in the cylinders but only way to know for sure is testing. Test procedure is in Manual 28 (90-863160) Section 5A Output pressure is between 2200-2600 psi The cylinder rebuild kits are fairly inexpensive
  12. alldodge

    Q5 bilge pump

    Welcome Post a pic and maybe someone will have an idea
  13. alldodge

    Steering actuator leaking... replaced two years ago...

    In most cases it's the lines or fittings that are leaking. The cooler has next to no pressure on it because it's on the return side.
  14. alldodge

    Electric Steering for 2005 Volvo Penta?

    Download Dometric catalog, has kits for I/O and OB
  15. alldodge

    Error closed loop gasoline bank 2

    The error with Bank 2 is because there is to much fuel. The excess fuel can be from a fuel system, leaky injectors, bad/no spark, bad connection. The plugs look real clean, when were they replaced? Your motor uses the HVS distributor and the cap has a high failure rate. The cap can look...
  16. alldodge

    Thread seal question

    no, that is a compression fitting
  17. alldodge

    Tonneau Cover

    Looking for best Tonneau cover. Have always had ARE fiberglass ones but now want one that is secure and not able to be ripped open with a pocket knife. Don't want the metal roll out or the ones that fold down inside the bed. Finding the fold up should work. Anyone have one of these they like?
  18. alldodge

    Starter Bolts 1985 Merc A1-G1 3.0 140hp

    Search for GM starter bolts Can find them at all local auto parts stores
  19. alldodge

    No Spark, feels like I’ve tried everything.

    I don't think it's the coil, but with coil voltage on purple wire switching like the above mentioned is a problem
Top