Search results

  1. jerryjerry05

    Greasing the mid section, zerk problems

    I was asked about adding grease to the mid section and the zerks coming out?? The Force/Chryslers, the zerks were pushed in and not threaded:( When the grease is added without proper preparation the zerks come out. IF?? you do regular maint from initial purchase then you don't usually have to...
  2. jerryjerry05

    Low oil alarm, questions

    As I understand the alarm, for low oil it has an intermittent beep and then it increases to a steady alarm. Yes /No ? Can someone explain the beeps and alarms? If there is water in the gas filter, what alarm sound would I get. Thanks, Jerry
  3. jerryjerry05

    Service bulletins?

    Nobody answered my other post so I'll try something different. https://forums.iboats.com/forum/engine-repair-and-maintenance/mercury-mariner-outboards/10631353-running-hot-on-1-bank How do I research service bulletins regarding thermostat upgrades or dropping the temp by changing thermostats...
  4. jerryjerry05

    Running hot on 1 bank.

    1999 200hp EFI New impeller, new thermostats 143d, new pressure relief. I changed position of the thermos' and made no difference.? The stbd. side runs hot and the alarm sounds off. Continuous solid tone. The oil's full. The lower unit's new. The high pressure pump's new. Ne thermo;s. I have...
  5. jerryjerry05

    Nordin

    Haven't seen Nordin on here lately. Anyone keep in contact with him?
  6. jerryjerry05

    Mercury 2002 225EFI 30"

    I have a 30" shaft on my motor. It's a solid shaft no connectors. What would it take to make it a 25"\ I know removing the 5" extension would be part of it. But what about the shift shaft and other parts?? Thanks, Jerry
  7. jerryjerry05

    Not permitted

    Not Permitted
  8. jerryjerry05

    2002 225 Mercury EFI

    My 2002 Mercury 225 EFI at idle it runs rough. 1225433ZY XXL SW Almost like there's water in the system(no water, clean/ new filters) After it gets a little past idle it smooth's out and runs really good. Compression is 150# all 6 Thanks,Jerry
  9. jerryjerry05

    Yamaha oil tank system DANGER!!!

    The PROBLEM with Yam's oil tank: the tank should be cleaned out YEARLY!!! There is usually some condensation in the tanks(both) one on the motor and the one in the boat. The condensation forms and settles in the bottom. There it forms an algae that actually grows in oil and diesel fuel. This...
  10. jerryjerry05

    Thermostat part #??

    2002 Mercury 225 EFI ​OT 555086 or 1225433ZY ​I can find the part #s for the thermostat kit that has the thermo's and new covers. ​Don't need the covers. I just need the part # for the thermostat. Seems they don't want you to buy just 1 thermostat and insist you get 2 and covers to go with...
  11. jerryjerry05

    Can anyone give me the breakdown??

    150TXR26G4XSO7891S found on a Yam. Can you tell me what it all means? ​
  12. jerryjerry05

    change from battery CD system with dist to regular auto typ system

    A while back someone posted a bunch of stuff on changing from a Prestolite/mag power to a points ignition system with a coil. ​It showed picks and part on how and what you'd need to change over. ​ANYBODY have a link to this post?? THANKS!!
  13. jerryjerry05

    Some hints on the T@T repairing the relief valve.

    Here are a few pics and descriptions on the T@T relief valve repair You will also need a propane torch and a small pick set.. I managed to get these apart without any other tools Remove the o-rings and keep them. You might need to re-use them. The o-rings don't usually go bad. Once the tools...
  14. jerryjerry05

    Hyd. steering excess play.

    Just repowered with a 2002 225 and used the hyd. steering I had prior. It turns but when setting you can move the motor back and forth about 1-2 inches. All the connections are tight. ​The steering seems to move back and forth in the cyl. ​The motors I had before ere solid and never moved. I...
  15. jerryjerry05

    2002 Mercury EFI

    The top and lower cowl was damaged in shipping.. ​Anybody know where I can get a good used replacement?? OT555086 mod 1225433ZY The difference in a lot is the area where the whizzer tube and water pickup is located. I can work around that. THANKS!!
  16. jerryjerry05

    Speedometer block pressure system.

    This is a "new to me" motor. ​2002 225 EFI OT555086 The speedometer bock pressure system?? What does it do? The hose from the lower to the motor is cut or broken? THANKS!!
  17. jerryjerry05

    ID

    2002 Mercury 3.0 225 EFI ​Looking for the location of the silver plug with the serial #s I looked and looked but no luck?? did find this on a sticker under the cowl.1225433zy ​Thanks, Jerry
  18. jerryjerry05

    2002 Mercury EFI

    I2254332Y T555086 Does this motor have a rev limiter? Where can I get a spec sheet or maybe an owners manual, something that can tell me about the motor?? Thanks.Jerry
  19. jerryjerry05

    Mercury props.

    Just picked up a 2002 225 EFI Came with 2 props. ​The one on it is a Mirage SS 17p ​The spare looks like the standard one. ​SS 17p but shorter and wider blades. I'm guessing that the guy paid a bunch of $$ and was using the Mirage that it's probably the better of the 2?? The cavitation plate...
  20. jerryjerry05

    Cowl upper and lower

    2002 Mercury 225 I225433ZY XL SW 30" I couldn't see a tag or the silver plug(motors on it's side) The upper and lower cowls both need replacing. ​The BIG question is:: will any other years or models swap over? ​The mid section is about the same and from the parts diagrams the bolts might...
Top