Search results

  1. 9

    2004 F115 Regulator Rectifier Blows Every 12 Hours

    this is one reason I suggested a bad connection
  2. 9

    Hydrofoil Stabilizer for Outboard Motors ?

    my little 16ft Xpress came with one on the 40, I took it off and could not stop the boat from proposing unless I put a bunch of weight up front. transom wedges would be needed to get my motor to kick in far enough to stop it without the stingray foil
  3. 9

    2004 F115 Regulator Rectifier Blows Every 12 Hours

    from what I have read, bad battery connections can cause RR to fail. wing nuts are frowned on. see what you can find online and start you searching
  4. 9

    2004 F115 Regulator Rectifier Blows Every 12 Hours

    that is not what you posted in the original post, so how can we help? having 11.9 to 14.4v when running is a problem. look for bad connections is all I have
  5. 9

    2004 F115 Regulator Rectifier Blows Every 12 Hours

    or a bad connection on the positive or neg side
  6. 9

    Lower Unit Oil Leak

    big question is how long has that water/saltwater been in that gear case? bearings and gears rust and go south as you keep running even with new lube. even the smallest bit of pitting will cause failure when run long enough. inspection would be a good thing IMHO
  7. 9

    Lower Unit Oil Leak

    I would just buy a new seal housing to put back in if you plan on pulling it on a motor that old. but before doing that I think doing the pressure and vacuum test in your service manual on the lower would be a good idea
  8. 9

    Lower Unit Oil Leak

    the original post said he had water in the gear case also
  9. 9

    Lower Unit Oil Leak

    it is just a drain hole to let water out above the water pump. that cavity has to drain
  10. 9

    Yamaha 30 SG carb emulsion tube

    did you find that info just using Yamaha 30SG?
  11. 9

    Yamaha 30 SG carb emulsion tube

    look at a parts breakdown for your motor to find part numbers
  12. 9

    Running engine on Trailer.

    depends on how much pressue and water flow you have, that is a small hose running to the power head. Owners manuals say not to. But some people say to use both muffs and the cowling fitting when running out of the water
  13. 9

    Repair or replace the exhaust baffle for ‘84 suzuki DT30

    looks like that plate should fit a 20,25 and 30, but not sure what years. so it might help in your search for used part https://www.boats.net/product/suzuki/14131-96301?ref=6c73441d232490abd6ae999f798a0d0930abf4a6
  14. 9

    1992 Suzuki dt 85 propeller hardware

    look at a parts breakdown of your motor, it will show what is needed, or just drop by a Suzuki outboard dealer and they should be able to look it up for you
  15. 9

    Yamaha F60TLRB 2003 4 stoke - running wonky

    let it sit overnight and fire it up again tomorrow to see if it clears anything up. let it run sometime again and then let it sit overnight again. then one more time Sunday, if no help carbs will need to come off and be cleaned
  16. 9

    2008 DF90 won't start.

    I was just getting at low voltage to injectors only during cranking, and I would make sure the voltage into the system was good while cranking to eleminate that kind of problem. I have no idea, but a bad connection of either positive or negative can cause low voltage while under heavy load to...
  17. 9

    over heat alarm 150 hp Yamaha 4 stroke 2006

    seems I remember reading about a temp sensor and another switch or something that monitors temps. Yes let us know what you come up with
  18. 9

    2008 DF90 won't start.

    Since I know nothing about this motor, I have to ask where was the places you checked the voltages? right at the ECU? were the wires hooked up to those terminals when you did the tests? Did you test without them hooked up? can you test the voltage to the ECU or relays during cranking to see if...
  19. 9

    2008 DF90 won't start.

    If you have good voltage with just the switch on and not during cranking, I would think the cranking is pulling down the voltage or you have a ground problem. have you checked other places to see what voltage is showing while cranking?
  20. 9

    2008 DF90 won't start.

    Look one block above the ECU failure block if the voltage in not OK on those 4 points
Top