Search results

  1. alldodge

    Propeller

    I wouldn't reduce pitch, while it will have better hole shot but the rpm will increase and can over rev. If you have an aluminum prop now could look at same pitch stainless
  2. alldodge

    Tune-up

    Double check
  3. alldodge

    5.0 Gxi-ce 270-r misfires cyl 4&7 at full throttle

    Then we don't know if there is a injector problem or not at high rpm's. I can take a can of carb cleaner and 12V and test if they open/close and spary cleaner thru them. Need to be tested up to 6000 rpm so they can seen if any are falling off
  4. alldodge

    5.0 Gxi-ce 270-r misfires cyl 4&7 at full throttle

    Who did your injectors? Did you get a printout of before and after? Are you sure RPM's are correct, checked with hand held?
  5. alldodge

    Volvo 5.0 gxi Stalls at idle. Hard start.

    There "should" be no drop in rpm in or out of gear with the MPI, that's what's the IAC for. What is the reading of the IAC when it's idling at 1000? If its below 40 then it's trying to slow but that's all it has. Need to compare IAC readings with idle rpm
  6. alldodge

    4.3 Mercruiser MPI Chugging/Surging and Beeping during turns/Waves

    Read O2 sensor and might have CAT so don't know
  7. alldodge

    4.3 Mercruiser MPI Chugging/Surging and Beeping during turns/Waves

    Above my pay grade but might be something with the Adaptive Speed control @muc Boat should keep the rpms constant but somehow the PCM goes into la la land when it's needed, but to even get started would need a serial number
  8. alldodge

    Starter wont engage flywheel.

    What about at the red wire on the coil?
  9. alldodge

    Fluids for Glastron GXL 235 question

    Yes, either will work
  10. alldodge

    Fluids for Glastron GXL 235 question

    Merc power Trim and steering fluid or ATF with Mercon
  11. alldodge

    Thunderbolt 4

    If connections are good and pickup is still working it will continue to run. Have seen them worst and they still run. The new sensors have an extra ground wire and mostly made of plastic
  12. alldodge

    Fluids for Glastron GXL 235 question

    To be able to answer correctly would need to know what motor?
  13. alldodge

    Hooked up my battery with the wrong polarity

    Most likely blew the ECM Just keep tracing wires and hope it's just a fuse you haven't found yet
  14. alldodge

    Oil pan drain hose

    I moved your comment from an old thread to a new one
  15. alldodge

    3.0L alpha one nearly new runs unsmooth

    Welcome to iboats Which 3.0 is it, there is several different variations? Have a serial number?
  16. alldodge

    Starter wont engage flywheel.

    Not necessarily, a weak spark can be the Distributor control. The Dist in simple terms contains a fancy switch. The coil + side has power and the - side is grounded thereby collapsing the filed and the spark is released. A weak spark can be that the module is not working correctly. With the...
  17. alldodge

    1991 Chris Craft 360 Express, Help broken water pipe

    Really doubt if things like that may even be documented. Might have a chance contacting Chris Craft but most just have general prints. Hope someone can advise If it was mine I would just plumb it like a house. Cold Tank to pump, Tee off to Hot water tank and down port side to another Tee...
  18. alldodge

    1991 Chris Craft 360 Express, Help broken water pipe

    Welcome to iBoats Which water pipe? Can you post a pic?
Top