Search results

  1. alldodge

    My boat is being a boat . . .

    Nice work
  2. alldodge

    Gimbal bearing. Is this normal?

    Looks like a good greaseable bearing other then the manufacture didn't debur before installing bearing in the race
  3. alldodge

    4.3 GXI-F Volvo Penta cranks but will not start

    You have a loose and/or corrosion issue. Might even be the key switch, but start with the Bat and clean to all shinny metal. With Bat disconnected clean grounds and positive cable connections. The blown fuse could be a chafed wire
  4. alldodge

    5.7 MPI Misfires Under Load

    Post the file here, folks like @tpenfield , @muc and couple others can have a look and even you can post screen shots
  5. alldodge

    I/O taking on water while sitting not moving

    Should never see any kind of sealant on the transom, if you do then it has started to leak and someone used a bandaid If transom bolts are ever loose then transom is soft, they never get loose otherwise You need to rebuild the transom
  6. alldodge

    U Joints

    If all props of same pitch had the same performance then there would be no need for others. If you want what you have and a bit better, and at cheaper cost gets yours repaired.
  7. alldodge

    U Joints

    Original comes out to 75832T1 item 13 https://www.mercruiserparts.com/bam/subassembly/30870/2203/70 When searching it comes up a Sierra 18-2174 Searching iboats it shows 2 different ones but would suggest stick with the 2174 https://www.iboats.com/shop/catalogsearch/result/?q=75832T1
  8. alldodge

    5.0 mercruiser won’t idle under 1100(ish) rpm’s

    If ya got a vacuum line on the carb it's automotive, but put a vacuum gauge on it before replacing to see what the reading is
  9. alldodge

    2006 Seadoo GTI 130 loud engine

    Agree, with less water going in the exhaust it will get louder
  10. alldodge

    2008 250 optimax pro XS steady beep

    A scanner is always best to have with the new motors. Don't know for sure but most sensors work from a switch closing. Have you tried disconnecting the oil and water separator to see if it stops?
  11. alldodge

    2006 Seadoo GTI 130 loud engine

    Need more info to get an idea of what your discussing Is it new to you Doo, or just louder sound?
  12. alldodge

    Mercruiser 383 Mag Stroker MPFI Bogs Over 3000 rpm

    You have a HSV distributor and cannot be replaced with another type without many other changes Dorman makes ear repair. This may not be yours, its just FYI...
  13. alldodge

    Stalling and Starting problems

    Yes Yes, but need to get the air out to get accurate reading The easiest way is with the fitting above and a Vac fuel pump tester which can normally be borrowed from auto parts store https://www.harborfreight.com/fuel-pump-and-vacuum-tester-62637.html Remove the steel line from the carb Note...
  14. alldodge

    My boat is being a boat . . .

    Maybe I could give ya Eddie Young's number and he could build ya a couple of 530HP motors. I will come up easy then :censored:
  15. alldodge

    Guest Charger keeps blowing 5A fuse

    Welcome to iBoats Start by checking your batteries. A fully changed Bat will read 12.6 to 12.7V. If the Bat reads much lower then that it could be it has a shorted cell If Bats read good then it is probably the charger
  16. alldodge

    Stalling and Starting problems

    Merc makes one but they kind of high 91-18078 but it's designed to use the hand held vacuum fuel pump tester But could also get some 3/8 gas line, a plastic Tee and some hose clamps. At max of 10 psi, line and hose claps will work. Most auto parts places will have a straight or elbow fitting...
  17. alldodge

    OMC starter solenoid wiring help

    I would guess the solenoid on the starter is the issue. Connecting a hot to that terminal and then energizing the slave relay you should se sparks
  18. alldodge

    Mercruiser 6.2 - Water distribution housing

    The tube should go to the air pump on top the motor next to the thermostat housing. The tube connects to the air pump to purge water out during winterization Many have had cracked housings and the biggest reason is are draining with pump the drain plug is reinstalled. Later there is a small...
  19. alldodge

    New Chaparral Electrical Problems

    The new motors have 12V stay alive power with fuses coming from the Bats. Might be a loose connection on the small wires or even a fuse not fully plugged in. Look for the fuses/wires at the Bats
  20. alldodge

    Ignition switch does not shut engine off.

    Without a wiring diagram we're going to be guessing. Going to see if I can find find a diagram. Can you post some pics of the master key and helm switches?
Top